Site work for a water / sewer project in Warrensburg, Missouri. Working plans call for site work for a water / sewer project.

***As of March 1,2019 project has been cancelled due to above budget. No re-bid decision yet. Any and all communication from bidders regarding specifications, requirements, competitive procurement process, etc., must be directed to Roderick Woolen at rwoolen@ucmo.edu. Communication made with parties outside of Procurement may result in your solicitation response being disqualified. MBE/WBE Percentage Goal: a. The bidder shall have as a goal subcontracting not less than five percent (5%) of the awarded contract price for work to be performed of MBE/WBE(s). The last time/date to submit questions is 10:00AM CT on Thursday, January 10, 2019. Email or fax questions to the Buyer as indicated in the Bid Contact Information section; The project start date shall be no earlier than Friday, March 15, 2019. The desired project completion date shall be no later than 5:00 p.m. CT on Saturday, March 23, 2019; Expected announcement of award is during the month of January 2019. This requirement may require UCM Board of Governors approval, which may delay the award announcement; All prospective bidders may attend the bid closing held on Thursday, January 17, 2019 at 2:00PM CT at the Procurement Office Conference Room 113, 415 East Clark Street, Building A, Warrensburg, MO 64093. The Morrow-Garrison Student Recreation and Wellness building at the University of Central Missouri in Warrensburg, MO was completed in 2010. This project utilizes a geothermal condenser water system containing approximately 20,000 gallons of water with 10% methanol and 3% glycol inhibitor (by volume). A summary of the equipment connected to condenser water includes (approximately): - 85 water source heat pumps with autoflow balance valves - 3 water source heat pump DOAS units with natural gas reheat and energy wheel (roof) - 3 water source heat pump RTUs (roof) - 2 water-to-water heat pumps - 1 fluid cooler (roof) - 1 expansion tank - 1 air separator - 1 air-dirt separator - 8 pumps SCOPE OF WORK: The following is a description of the scope of work required for this project: - Disconnected and loop supply/return lines prior to purging of equipment. Hydronic accessories need to be protected from elevated system pressure during purging. - Care should be taken to not damage hydronic accessories and components during system purging, including valves, strainers, gauges and other components. - Conduct a purge of both the ground source and building condenser water systems o This must be done with specialized pumping equipment designed for system purging. Utilizing the building pumps is not possible. o Finch Drilling is aware of the project and can provide a price for this portion of the work. Alternate companies may also provide this service provided sufficient equipment history of this work are available. o System pressure during the purge shall not exceed 70 PSI. - Flush each unit condenser individually. - Clean and inspect strainers and autoflow valve cartridges. Replace strainers and cartridges as necessary - Re-connect all equipment once purge is complete and verify proper operation. - Document deficient components that require repair or replacement. Provide a description of the component, issue, and recommended action as well as estimated costs.