Renovation of a detention facility in Union Springs, Alabama. Completed plans call for the renovation of a detention facility.

Due to security reasons please contact Goodwyn Mills & Cawood Inc. to obtain the plans and specifications. Prequalification proposal requirements may be obtained from the Architect, by written request on the Contractor's company letterhead. The Work of the project includes, but is not limited to, selective demolition, security fencing, interior renovations; as specified and as indicated on the Drawings; coordination and supervision of the entire project; and all related work, as indicated in the Bid and Contract Documents. Bidders will be notified in writing on August 31, 2020, if they are Not qualified. Other sets for general contractors, and sets for subs and dealers, may be obtained with the same deposit, which will be refunded as above, less cost of printing, reproduction, handling and distribution, which is estimated to be the same as the deposit amount. Partial sets will not be available. All bidders bidding in amounts exceeding that established by the State Licensing Board for General Contractors must be licensed under the Provision of Title 34, Chapter 8, Code of Alabama, 1975, as amended, and must show such evidence of license before bidding or bid will not be received or considered by Architect or Owner; The bidder shall show such evidence by clearly displaying their current license number on the outside of the sealed envelope in which the proposal is delivered; Bidder must also include their current license number on the Proposal Form. To expedite distribution of bid documents, deposit check(s) should be faxed and mailed to Goodwyn, Mills and Cawood, Inc.; Attn: Jill Nelson; PO Box 242128; Montgomery, AL 36124; Fax No.: (334) 272-1566 (or emailed to: Jill.Nelson@gmcnetwork.com). A cashier's check or bid bond payable to Alabama Department of Corrections in an amount not less than five (5) percent of the amount of the bid, but in no event more than $10,000, must accompany the bidder's proposal. Performance and statutory Labor and Material Payment Bonds, insurance in compliance with requirements, and verification of E-Verify enrollment (also with Proposals), will be required at the signing of the Contract. Additional qualifications and requirements for General Contractor Bidders and separate Subcontractors and Manufacturers are indicated in the Bid and Contract Documents. The Owner reserves the right to reject any or all proposals, to waive technical errors, and/or abandon this process if, in their judgment, the best interests of the Owner will thereby be promoted.