Site work and paving for a road / highway in Bridgeport, California. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Estimated cost is between $2,000,000 to $2,500,000. From qualified General Engineering and Asphalt Paving contractors for the LONG VALLEY STREETS PROJECT (Project). The project is state-only funded under the State Transportation Improvement Program (STIP). The purpose of this Project is to rehabilitate approximately 5 miles of county roads within the communities of Long Valley, Crowley Lake, Sunny Slopes, and Swall Meadows. Road rehabilitation will include full depth reclamation on Substation Road, Wildrose Drive, Sierra Springs Road, Pearson Road (portion), Elderberry Circle, and Crowley Lake Circle. A combination of mill and/or conform grind with a hot mix asphalt overlay will be applied on Hilton Creek Drive, Hilton Creek Place, Aspen Terrace, Delta Drive, Placer Road (portion), Lake Manor Place, Meadow View Drive, Sunny Slopes Road, Montana / Wheeler View Road, Foothill Road, and the westerly portion of Mountain View Drive. Associated hot mix asphalt dikes, signs, paint striping, and paint markings are included in the project Each bid shall be made on the proposal forms contained in the Project Manual and must be accompanied by bid security in the amount of not less than 10 percent (10%) of the total bid. The Project and all work must be completed within 65 working days from the date of issuance of the Notice to Proceed. The Project and all work must be completed within 65 working days from the date of issuance of the Notice to Proceed. No contractor or subcontractor may be listed in a bid proposal or awarded a contract for this project unless registered with the Department of Industrial Relations pursuant to Labor Code section 1725.5 (unless one of the limited time extensions set forth in Labor Code section 1771.1 applies, in which case registration must be completed by the time of contract award). This Project is subject to compliance monitoring and enforcement by the Department of Industrial Relations In addition, the successful bidder, as the Contractor, will be required to furnish a one- year warranty bond in an amount equalto 10 percent(10%) upon project completion, pursuant to the requirements in the Sample Standard Agreement.