Site work for a water / sewer project in Holdrege, Nebraska. Completed plans call for site work for a water / sewer project.

Bid 2 - Pipeline and Outfall Structures 1723 Burlington Street Holdrege, NE 68949 Phone: 308-995-6688 B. Site Access Tri-Basin NRD will obtain easements on the properties on which the wells and pipeline will be installed and will arrange for legal access to the sites. The Contractor will be responsible for physical access to the locations. Access must be coordinated with the TBNRD. The work required for the project is briefly described as follows: Bid #2- All materials and labor needed to install approximately 13,500 lineal feet of buried pipeline and concrete outfall structures The deadline for questions regarding bid specifications will be October 15, 2021. Envelopes containing the bids shall be sealed and must be accompanied by a certified check or bidder s bond in an amount of not less than five percent of the amount bid. The check or bond shall be made payable to the Tri-Basin NRD as security that the bidder to whom the award is made will enter into a contract to build the improvements bid upon and furnish the required bond. Tri-Basin NRD reserves the right to reject any or all bids and to waive any formalities in bidding. The successful bidder shall supply a Performance and Payment Bond executed by a Corporate Surety licensed in the State of Nebraska in an amount equal to 100% of its contract price. Upon acceptance of a bid a Notice of Award and contract will be issued. The bidder will execute AB-2 and file the contract within fifteen days from the date of the Notice of Award. A Notice to Proceed will then be issued, after which substantial completion of the work shall be achieved within 120 days of mobilization to the project site and no later than December 31, 2021 1. Installation of surface piping and measurement and control items, including a check valve, butterfly valve, pressure relief valve, backflow preventor, discharge elbows, and transition piping as generally shown in the attached figures. The facilities will tie into an existing earthen and concrete pad and discharge elbow. 2. Trenching, bedding, installation of steel and PVC discharge piping, backfilling, and regrading between the wells and a point adjacent to the river. 3. Furnishing and installation of a discharge structure at the designated points of discharge as shown in the plans, which will include formed concrete, steel grate covering the end of the discharge pipe and grouted riprap. 4. Final demonstration of system function *The list of planholders and/or interested bidders is not being tracked by the stakeholders involved with this project. If you are an interested contractor and wish to be listed as a bidder, please notify our editorial staff at addtobidlist@constructconnect.com. The project will construct a discharge pipe network from seven irrigation-style wells to three discharge locations along a drain/side channel near the Platte River. The purpose is to reallocate groundwater to the Platte River in times of need when the river is experiencing low water levels for the benefit of endangered species. The proposed pipeline network will temporarily impact 0.13 acre of palustrine emergent wetlands. The temporary impacts would result from open trenching and placement of the PVC/steel pipe. To accommodate, an approximately 40-foot-wide limits-of-construction (LOCs) buffer along the proposed pipeline route was used to determine the temporary impacts. The buffer was extended in areas where the LOCs will likely expand. Upon construction completion, the impacted areas would be backfilled appropriately, restored to preconstruction contours, and stabilized with a native seed mix.