Renovation of an educational facility in Detroit, Michigan. Completed plans call for the renovation of a educational facility.

**As of January 04, 2021, the project has not been awarded yet. A timeline for award is not yet determined. Wayne County Community College District is seeking proposals from qualified contractors for the Districtwide Projector and White Board Installation Project. Please return the following documents with your submission: 1. Proposal Page 2. Proof of three (3) years in business 3. Proof of business insurance 4. References (a minimum of three) 5. Addendum to Independent Contractor Agreement (supplied by the College) 6. Financial Statement (required only if your total bid is $50,000.00 or more) 7. Bid Guarantee (required if your total bid is $50,000.00 or more Some classrooms may deviate from "traditional" installation. Listed below are five potential Scope of Work (SOW) scenarios: Scope of Work #1 - Remove existing equipment and add new equipment - Remove existing ceiling mounted projector, white board, & projector screen. - Install and configure new projector, white board (to be mounted flush against the wall, without bowing), & computer unit. - Configure & calibrate the smart projector. - Provide & use face plates to cover up holes made for cabling. - Make sure that all white board that are mounted be flat and does not bow or flex. Remove existing equipment and add new equipment (2) - Remove existing white board, & projector screen. - Install and configure new projector, white board (to be mounted flush against the wall, without bowing), & computer unit. - Configure & calibrate the smart projector. - Provide & use face plates to cover up holes made for cabling. - Make sure that all white board that are mounted be flat and does not bow or flex. Remove existing equipment and add new equipment (3) - Remove projector & white/black board. - Install and configure new projector, white board (to be mounted flush against the wall, without bowing), & computer unit. - Configure & calibrate the smart projector. - Provide & use face plates to cover up holes made for cabling. - Make sure that all white board that are mounted be flat and does not bow or flex. Remove existing equipment and add new equipment (4) - Remove white/black board. - Install and configure new projector, white board (to be mounted flush against the wall, without bowing), & computer unit. - Configure & calibrate the smart projector. - Provide & use face plates to cover up holes made for cabling. - Make sure that all white board that are mounted be flat and does not bow or flex. Install new equipment (no removal) - Install and configure new projector, white board (to be mounted flush against the wall, without bowing), & computer unit, or - Install new 55" monitor & computer unit. - Configure & calibrate the smart projector. - Provide & use face plates to cover up holes made for cabling. - Make sure that all white board that are mounted be flat and does not bow or flex. All cables should be fished in the wall and not placed in raceway. Power and data will be installed prior to vendor installations. All questions must be received no later than Thursday, November 18, 2021 at 3:00 p.m. WCCCD CURTIS L. IVERY DOWNTOWN CAMPUS- 1001 West Fort Street Detroit, MI 48226 WCCCD DOWNRIVER CAMPUS - 21000 Northline Road Taylor, MI 48180 WCCCD EASTERN CAMPUS- 5901 Conner Avenue Detroit, MI 48213 WCCCD NORTHWEST CAMPUS - 8200 W. Outer Drive Detroit, MI 48219 -WCCCD TED SCOTT CAMPUS -9555 Haggerty Road Belleville, MI 48111