Site work and paving for a road / highway in Hamtramck, Michigan. Completed plans call for site work for a road / highway; and for paving for a road / highway.

5.80 mi of hot mix asphalt cold milling and resurfacing, pavement repairs and pavement markings on I-75 from Piquette Avenue to M-102 (8 Mile Road) in the cities of Highland Park and Hamtramck, Wayne County. This project includes two 5 year materials and workmanship pavement warranties and a 3 year materials and workmanship pavement warranty. I-75 (Chrysler Fwy.) is a six-lane to eight-lane (three to four lanes in each direction) limited-access divided freeway with acceleration and deceleration lanes, and with numerous on and off ramps in consists of a 3-inch and/or 3.5-inch HMA overlay over a 10-inch concrete pavement. 1. Pavement surface preparation 2. Full-depth concrete pavement repairs 3. Cold milling mainline pavement to a depth of 1.5 inches 4. Surface repair for joints and cracks (Detail 7) 5. Full-depth repair for joints and cracks (Detail 8) 6. Resurfacing mainline pavement to a depth of 1.5 inches 7. Miscellaneous curb and gutter and shoulder repairs 8. Intermittent drainage structures and sewer leads cleanout 9. Intermittent drainage structures adjust 10. Intermittent drainage structures inlet protection 11. Temporary pavement markings installation 12. Permanent pavement markings installation 13. Maintenance of Traffic Control Sec Job No Federal No NH 82252 208614A 22A0087 Control Section: 82252 Job Number: 208614A Net classification required for this project is 9828 Cb In addition to the above minimum prequalification requirement for prime contractors this project includes a subclassification of N9-3A. If the prime contractor is not prequalified in this subclassification it must use a prequalified subcontractor. This subcontractor must be designated prior to award of the contract to the confirmed low bidder. MDOT - 2112 022 - Hot Mix Asphalt Cold Milling and Resurfacing, Pavement Repairs and Pavement Markings on I-75 MBE (17.7%), WBE (6.9%), DBE (5%) The entire project must be completed by the final completion date of September 25, 2022. SP Warranty Special Provision Description Bond Limits Total yrs 20SP501(M) M&WPW for Multiple Course HMA Overlays on Concrete Pavement 5 20SP501(P) M&WPW for Cold Milling & One Course HMA Overlay (CPM) 3 20SP602(B) M&WPW for New/Reconstructed Jointed Plain Concrete Pavement 5