Site work and new construction of a civil project in Fort Worth, Texas. Completed plans call for the construction of a water / sewer project; and for site work for a water / sewer project.

The major work will consist of the (approximate) following: Site Work, Yard Piping, and Appurtenances, 5,200 SF Pump Station Building, Three (3) 4,750 gpm horizontal split case pumps and 400 HP motors, Three (3) 7,000 gpm horizontal split case pumps and 300 HP motors, and One (1) 3 Million Gallon Prestressed Concrete Ground Storage Tank. A. Furnish all labor, materials and equipment required to install, test and provide an operational, electrical system as specified and as shown on the Drawings. B. All equipment described herein shall be submitted and furnished as an integral part of 8 equipment specified elsewhere in these Specifications. C. All electrical work provided under any Division of the Specifications shall fully comply with the requirements of Division 26. D. The work shall include furnishing, installing and testing the equipment and materials detailed in each Section of Division 26. E. The work shall include furnishing and installing the following: 1. Electrical service from the Oncor Electric. 2. Provide a complete raceway system, wire and field connections for all motors, motor controllers, control devices, control panels and electrical equipment furnished under other Divisions. Coordinate construction schedule and electrical interface with the supplier of electrical equipment specified under other Divisions as required by the Contract Documents. 3. Provide a complete raceway system, wiring and terminations for all field-mounted instruments furnished and mounted under other Divisions, including process instrumentation primary elements, transmitters, local indicators and control panels. Lightning and surge protection equipment wiring at process instrumentation transmitters. Install vendor furnished cables specified under other Divisions as required by the Contract Documents. 4. Provide a complete raceway system for the Data Cables and specialty cable systems, including those furnished under other Divisions. Install the Data Cables and other specialty cable systems, in accordance with the system manufacturers' installation instructions. Review the raceway layout, prior to installation, with the Process Control System supplier and the cable manufacturer to ensure raceway compatibility with the systems and materials being furnished. Where redundant cables are furnished, install the cables in separate raceways as required by the Contract Documents. 5. Furnish and install precast electrical and instrumentation manholes, hand holes and light pole foundations as required by the Contract Documents. Pole foundations shall be designed and installed in accordance with the structural Divisions of these Specifications. F. Provide all tools, equipment, supplies, and shall perform all labor required to install the equipment specified in the Contract Documents to install, test, and place into satisfactory operation in the time specified for completion in the Contract Documents. Failure of any of the participants in executing the requirements of this Contract to perform the work as specified shall not constitute an acceptable reason for the Owner to grant any change in the Contract Price or additions to the Contract Time. $18M to $20M *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.