Renovation of a mixed-use development in Tulsa, Oklahoma. Completed plans call for the renovation of a educational facility.

The bidding process will be in compliance with the Public Competitive Bidding Act of 1974. By this notice, all provisions of the act apply to this project and are incorporated into notice by reference. Upon receipt of an acceptable bid, the contract will be awarded within thirty days after the opening of bids and the written contract executed within sixty days thereafter. Contractor qualification statement must be submitted seven (7) calendar days prior to bid date to the Owner, if not currently on file. Attention is called to the fact that a designated completion date for this project site will be established based on the number of calendar days, as stated in the accepted bid, required to complete the Project work. There will be a $2500 Liquidated Damages Clause for each day the contract is not completed. The scheduled completion date will be a very significant and material factor to the owner when selecting the Lowest Responsible Bid. Each Bidder must include (in the space provided on the Bid Form) the number of calendar days, which the Bidder will require to complete the specified Project. Failure to comply with the above bid requirements will result in return of unopened Bid Proposal. Bid Documents may be obtained from: http://www.tulsaschools.org/connect-with-us/partner-with-us/b ond-bids Owner reserves the right to reject any or all bids and to waive informalities or minor irregularities in any bid. All work should be complete by August 1, 2022. Existing gas service to be revised by removing all gas piping from removed HVAC equipment. Additional gas piping will be installed from the meter to the locations of new HVAC equipment on roof. Verify new building gas connected load with Oklahoma Natural Gas Company (ONG) to verify existing building gas service size to the meter and meter size is correct for the new connected capacity. System shall be installed complete with all modifications or replacement to the existing gas meter, gas regulators, system shut-off valves, required increase ofpipe size of existing gas service piping or system branch piping, pressure testing of existing piping system, or other system modifications such as rerouting of any existing gas piping identified to be located under the building or otherwise not installed per current code requirements. Provide gas piping system required for the installation of all new gas fired equipment and appliances, and the continued service to all existing gas piping systems. Gas piping system shall include all required pressure regulators, relief piping, valves, unions, cathodic protection, electrical grounding, and accessories required for a complete system. Demolition- Disconnect, remove, and prepare existing systems for completion of the Scope of Work ofthis section, as shown on drawings and as affected by other sections noted herein. o Work abandoned in place: Cut and remove back to system main. Cap piping and patch surface to match final finish. Record all work abandoned in place on record drawings. Permanently mark all work abandoned in place and not operational. o Removal: Remove equipment and materials from the Project site to approved location daily. o Required disconnection or interruption of existing building systems shall be coordinated with the Owner prior to performing Work. All buildings users and departments affected by the interruption shall be notified as directed by the Owner within the time frame required by the Owner. o All equipment removed as a part of this Work shall be discarded in proper manner according to all applicable laws and removed completely from this site.