Renovation of a mixed-use development in Portage, Michigan. Completed plans call for the renovation of a educational facility.

The Board will not accept a bid proposal that does not include a sworn and notarized familial disclosure statement disclosing any familial relationship that exists between the owner or an employee of the bidder and any employee of the Portage Public School District or member of the Board of Education. The Board of Education reserves the right to accept or reject any or all bids, either in whole or in part; to award contract to other than low bidder; to waive any irregularities and/or informalities; and in general to make awards in any manner deemed to be in the best interest of Portage Public Schools. *The list of planholders and/or interested bidders is not being tracked by the stakeholders involved with this project. If you are an interested contractor and wish to be listed as a bidder, please notify our editorial staff at addtobidlist@constructconnect.com. and or procedures guidelines. b. Pre-cleaning the floor with a water-based cleaner such as Hillyard Super Shine All or Tack It recommended by the finish manufacturer. c. Dry screening the floor with 120-grit screens (at a rate of 250 2/side of screen) using a dust collecng device aached to the floor machine. i. Please note that there is very lile finish on the CMS and NMS gym floors. Proper precauons should be taken and noted, as to not damage the exisng paint. d. Remove all dust through vacuuming the enre floor surface surrounding areas, corners, edges, etc. e. Tack the floor using Hillyard Tack It, Kleen up Solvent or a comparable product unl the floor is free of all dust and debris. f. Apply 1 coat of gym floor finish that is an MFMA approved oil-modified urethane wood floor finish with an applicator recommended by the finish manufacturer. Gym floor finish should be Hillyard 450 Gym Finish or a comparable product (for both playability and durability) g. Allow the floor to cure properly to accept a second coat of gym floor finish. h. Prepare the floor for the second coat of finish by abrading the floor with maroon pads or the manufacturer recommended pad system. i. Vacuum and tack the floor with Hillyard Tack-It, Kleen Up Solvent or a comparable product to remove all dust and debris from the floor surface. j. Apply 1 coat of gym floor finish that is an MFMA approved oil-modified urethane wood floor finish with an applicator recommended by the finish manufacturer. Gym floor finish should be Hillyard 450 Gym Finish or a comparable product (for both playability and durability)