Site work and paving for a mixed-use development in Colma, California. Completed plans call for site work for a sidewalk / parking lot; for paving for a sidewalk / parking lot; and water / sewer project.

Pre-Qualification for Bidders: Not Required Dial by your location +1 669-900-6833 US (San Jose) +1 253-215-8782 US (Tacoma) +1 346-248-7799 US (Houston) +1 312-626-6799 US (Chicago) +1 929-205-6099 US (New York) +1 301-715-8592 US (Washington DC) 877-853-5257 US Toll-free 888-475-4499 US Toll-free 833-548-0276 US Toll-free 833-548-0282 US Toll-free Meeting ID: 878 7425 2550 The work generally consists of items listed below and is located along Hillside Boulevard from Lincoln Street to Lawndale Boulevard, South San Francisco, CA. A detailed scope of work is included in the bid documents. - Install project signs; - Provide notification and postings required by the special provisions and specifications; - Provide traffic control throughout the duration of the project per the approved traffic control plan; - Prepare Water Pollution Control Program and submit to the City for review for approval as part of the project submittal; - Comply with the Construction Waste Management Plan (WMP) ordinance reporting requirements of the City (See appendix page for the procedures and forms);Conform with existing asphalt concrete; - Construct full depth hot mix asphalt pavement at locations designated on the plans; - Sawcut existing asphalt concrete and remove existing pavement section; - Remove existing sidewalk, curb and gutter and off-haul and dispose of all concrete material; - Install new curb ramps; - Install drainage components and trench drains - Construct new sidewalks, curb ramps with truncated domes, and curb and gutter; - Install a new traffic signal at the Hillside Boulevard and Lincoln Street intersection; Adjust vehicle detection at the Hillside Boulevard at Lawndale Boulevard, Hillside Boulevard at Chestnut Avenue and Hillside Boulevard at Stonegate Drive intersections; install cellular communication devices and reconnect existing signal interconnect cable; - Remove existing striping and markings and install new pavement striping, markings and markers; - Apply slurry seal along the full width of pavement for entire project limit - Replace existing chain link and wood fence - Demobilize and complete Final clean-up