Site work and renovation of a water / sewer project in Valparaiso, Indiana. Completed plans call for the renovation of a water / sewer project; and for site work for a water / sewer project.

500,000 Gallon Double Ellipse Exterior Repaint with Containment Wet Interior Repaint And Miscellaneous Repairs Commence work on or after May 1, 2022 Work hours are 7:00 A.M. to 7:00 P.M. Monday through Friday and 8:00AM to 7:00PM Saturday and Sunday. Substantial Completion by November 1, 2022, including cure and disinfection time. The tank may be out-of-service a maximum of 55 days. Liquidated damages are applicable and begin after 55 days out-of-service or after Substantial Completion date whichever is the earlier date. Liquidated damages at $1,250/calendar day shall apply after this date. Ready for Final Payment Date shall be thirty (30) days after date. Substantial Completion Date based on out-of-service days or scheduled Substantial Completion, or as adjusted by Change Order; or actual Substantial Completion if earlier. Liquidated damages after Ready for Final Payment Date of $250/day shall apply. Liquidated damages are cumulative if damages from Substantial Completion and Ready for Final Payment overlap. In addition, Special Damages, fines, or Set-offs may also apply per Bid/Agreement Form. SCOPE of WORK Tank Information: The structure is a 500,000 gallon double ellipse elevated water storage tank with an estimated high-water level of 130 ft. located at 205 Billings St. in Valparaiso, Indiana. The work includes: Exterior: Abrasive blast clean to a SSPC-SP6 commercial standard within containment and apply a four (4) coat zinc epoxy urethane system. Wet Interior: Abrasive blast clean to a SSPC-SP10 near-white metal standard and apply a three (3) coat zinc epoxy system. Apply a polyurethane caulk to the roof lap seams. Foundation: Abrasive blast clean and apply a two (2) coat epoxy system. Repairs: 1) Install riser manway. 2) Replace the riser manway gasket. 3) Replace the wet interior roof hatch. 4) Adjust the loose sway rods. 5) Install a fall prevention device on the leg ladder. 6) Install a wet interior ladder. 7) Install a roof/sidewall platform. 8) Replace overflow screen. 9) Replace vent with a frost-free roof vent. 10) Install cathodic clips and pressure fitting. 11) Weld steel plates over the cathodic lift holes. 12) Remove the existing cathodic protection system. 13) Replace the aviation lights. 14) Install bowl rigging couplings. 15) Balcony drain holes. 16) Balcony access modification. 17) Replace riser rod attachment points at the riser. 18) Overflow pipe supports. 19) Riser grate replacement. MISCELLANEOUS A. The antenna owners will temporarily remove the antennas and cables prior to the start of the project. B. Contractor may need to remove fence or a fence section for set-up of containment perimeter. Fence to be reinstalled after work has been completed. Condition of fence to be equal to the original fence, or better. Quality for reinstallation is solely at the discretion of the Owner unless pictorial documentation is completed by the Contractor. C. There are lights on the structure to illuminate the ground, the Contractor is to remove the lights and conduit and reinstall after the topcoat is applied. D. The logo design is not final and is subject to change.