Renovation of a residential development in Theodore, Alabama. Completed plans call for the renovation of a residential development.

If you have any questions, you can call Ginny Kirby at 251-208-6297. Areas that are found to be spaced decked shall be covered with 1/2"exterior grade sheathing material after removing the existing decking. It is the contractors responsibility to ensure the framing and structure will support the additional load. Remove existing roofing materials down to bare decking. Check all roof trusses/rafters and repair/replace as needed to ensure that new roof structure is flat and smooth without rises or depressions in roof system. Replace all rotten, broken, un-even, weak, or deteriorated decking framing, fascia and etc. Any exposed repaired or replace wood should be protected from the elements, painted to match existing color or white. Replaced/repaired decking shall be level and ready to accept felt and shingles. Check all roof trusses for strength and stability before re-shingling house. Remove all unused elements, vents, etc., that are not operational and close them below roof level. Re-flash all valleys, vents, roof openings, and chimneys. Install new boots around all roof penetrations. Haul away debris immediately. Use a magnetic sweep around the perimeter of house and rake away any other debris. Cover entire roof decking with self-adhered roofing underlayment then install 15# asphalt impregnated felt underlayment Prepare roof decking to accept a ridge vent. Re-roof with a 30year dimensional class A fiberglass asphalt shingle. (Owners choice of color). Shingles must be 1st quality still in the wrapper. Seconds will not be accepted. Install drip rail around perimeter of house. Shingles shall have 1/2"to 1 1/2" overhang. Install roof over ridge vent with-in 2ft of end of ridge (end to end) or wind turbines, (minimum of two) as appropriate. New roof shall be structurally sound and leak free. Contractor shall warrant the roof to be completely leak free for one year.