Site work and paving for a road / highway in Lewistown, Montana. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Contractor will provide all labor, equipment, materials, incidentals and traffic control necessary to produce, haul, place, tack and compact approximately 1,042 tons of 3/4 " Commercial Plant Mix Grade S 64-28 asphalt mix material. The Contractor will be required to Cold Mill approximately 10,492 square yards of roadway, approximately 49 feet wide and 0.15 feet deep beginning at milepost 0.0 and ending at milepost 0.37. The overlay shall be paved 0.15 feet thick and approximately 49 feet wide. Contractor shall provide all labor, equipment, materials, traffic control and incidentals necessary to produce, haul, place, roll and broom approximately 10,492 square yards of laid-in-place chip seal. The chip seal will be approximately 0.37 miles long and 49 feet wide. Contractor shall provide CHFRS-2P asphalt emulsion and Type 1 chips. Traffic control with pilot cars must be maintained until dusk or fading light each workday as determined by the Project Manager. The emulsion application rate for chip seals is estimated at 0.45 gallons per square yard. The cover material application rate is estimated at 25 pounds per square yard. Actual application rates will be based on the chip design and the actual field adjustments. If the cover material application rate of 25 pounds per square yard is not sufficient to provide a quality job, the Project Managers will jointly determine what the new application rate should be. Contractor must furnish a water truck for dust control and wetting of chips. Arrangements must be made by the Contractor for acquiring water for wetting and sweeping. It will be the responsibility of the Contractor to determine the centerline and place reflective tabs prior to the chip seal. The Department will provide final striping. Contractor shall be responsible for all private property damage claims resulting from performance of the tasks described above. The Montana Department of Transportation (MDT) is accepting bids for Overlay and Chip Seal S-238 Lewistown Area. Additional details regarding the solicitation can be viewed electronically Questions or information relating to either specifications or requirements of this solicitation must be asked electronically Work can not start until after: July 1, 2022 Work is required to be completed on or before: June 9, 2023 Question Submission Close Date 4/27/2022 2:00 PM MDT