Renovation of a detention facility in Pampa, Texas. Completed plans call for the renovation of a detention facility.

Question Deadline: November 3, 2022 at 03:00 PM. The Anticipated Release Date of TDCJ Answer is Thursday November 4, 2022 SCOPE OF WORK A. Follow all Safety Procedures and TDCJ Risk Management Procedures to include the National Electrical Code, NFPA 70E and Life Safety Code. B. Remove all fencing from Service Entrance Transformer Pad No. 5 and extend the existing Concrete Slab to allow for the installation of a New 150 Amp Fused Safety Disconnect, a New Automatic Transfer Switch and a New 100 KW Diesel Generator. C. Install a New 150 Amp Fused Safety Disconnect, a New Automatic Transfer Switch, and a New 100 KW Diesel Generator with all required conductors, conduit, connections and equipment grounding. D. Install 4 - #2/0 THWN-2, 1 - #4 Ground in a 2" Conduit between the T9 Service Transformer to the New 150 Amp 480/277 V 3 Phase 4 Wire Fused Safety Disconnect. E. Install 4 - #2/0 THWN-2, 1 - #4 Ground in a 2" Conduit between the New 150 Amp 480/277 V 3 Phase 4 Wire Fused Safety Disconnect and the New Automatic Transfer Switch. F. Install 4 - #2/0 THWN-2, 1 - #4 Ground in a 2" Conduit between the New 100 KW Diesel Generator to the New Automatic Transfer Switch. G. Install 4 - #2/0 THWN-2, 1 - #4 Ground in a 2" Conduit between the New Automatic Transfer Switch to the existing Underground Conduit at the New Pull Box that was installed between the existing Underground and the HK Panel in the upstairs Gym. H. Locate and excavate the existing underground from the Transformer Pad No. 5 to the HK Panel in the upstairs Gym Electrical Room and install a New Pull Box to route the New Underground from the New Pull Box to the ATS. Abandon the existing underground and conductors from the New Pull Box to the Service Transformer. I. Install new fencing and double door gate on to the existing fence and single door gate. J. Test and commission the entire installation.