Site work and new construction of a military facility in McClellan, California. Completed plans call civil work for a military facility.

A. The selected Design Builder (DB) shall provide all labor, materials, tools and equipment, and services necessary for design, pre-construction, construction, and closeout of the project described here and other specific tasks as further defined by this request for proposal (RFP) - Not all work required is represented in the RFP and it is the designer's responsibility to verify existing conditions and confirm exact locations and quantities. B. The project includes either the relocation or remodel of approximately 19 existing telecommunications rooms (TRs) and one data center to bring them up to the Electronic Health Records Modernization (EHRM) IT standards while IT services remain operational. The DB shall provide a turn-key project for these rooms in accordance with VA Office of Information and Technology (OIT), EHRM infrastructure standards, physical security standards, and the TIL, as follows: 1. Design and installation of upgraded communication infrastructure (new data outlets, patch panels, patch cords, upgrade to Cat 6A cable where cabling is Cat 5 or below, fiber upgrade to OM4-rated multimode fiber-optic cable) as indicated in this RFP - Not all work required is represented in the RFP and it is the designer's responsibility to verify existing conditions and confirm exact locations and quantities. Remove cable/fiber being replaced or found abandoned in place. Anticipate, and include in proposal, a 15% increase in # of drops/data outlets, cables, and patch cords beyond numbers listed for each space in the Project Manual. 2. Design and installation of new redundant fiber infrastructure backbone at the McClellan Medical Center (VAMC) run from Building 98, Room 2S13A to building service entrances and within buildings as indicated in this RFP. Dual loop required to provide redundant feed to campus and throughout campus. Remove fiber being replaced or found abandoned in place. 3. Design and installation of all low voltage raceway systems and room fittings to support network equipment, including all required bracing/backing/mounting materials and back boxes to support installation of IT equipment. Active EHRM equipment in the data center will be provided and installed by CERNER and is not within the scope of this project. 4. Design and installation of required power, grounding, UPS, Building Management System interfaces, HVAC requirements, and other system requirements for TRs/data centers in the area or associated with the area of work. 5. Any specific coordination needs to be done with Cerner (through the VA COR), include those technical details, timelines. 6. Reconfiguration, expansion, and renovation of existing spaces as identified in this RFP to meet IT space and configuration requirements (demo, new construction). Design and installation of interior finishes in all areas affected by work under the scope of this RFP to meet OIT standards for TRs/data centers, and in coordination with the VA Interior Designer for non-IT spaces.