Renovation of a detention facility in Columbia, South Carolina. Completed plans call for the renovation of a detention facility.

Replace existing roof top heat pumps and gas packs and replace split system heat pumps as detailed on the drawings and in the specifications. Construction Cost Range: $1,000,00 to $1,400,000 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. All questions & correspondence concerning this Invitation shall be addressed to the A/E. A/E NAME: Mechanical Engineering Consulting Associates, Inc. A/E CONTACT: Kevin L. Stanley EMAIL: kstanley@mecainc.com TELEPHONE: (803) 765-9421 SCOPE A. The scope of this project is replacement of 2 split system heat pumps with new units as detailed on the drawings and specifications. A more detailed, but not exhaustive or inclusive list of scope requirements is shown below. The contractor shall review drawings and specifications carefully to determine the complete scope of the project and not depend solely on the description below. The following list is meant to serve as a general description of the scope of the project. B. Replace split system heat pumps as shown on the drawings and all items required for a complete and operating system. C. Modify/Add ductwork as herein specified and as indicated on mechanical drawings. D. Insulate all ductwork, piping, and equipment as herein specified and as indicated on mechanical drawings. Spring-type vibration isolators are not required. E. Outdoor refrigerant lines to be replaced complete. Insulate and enclose with weather-tight jacket. F. Start, test, adjust, balance and place into operation all systems via 3rd party T & B subcontractor under this contract. Extent of work for requirements indicated in specifications pertain to the systems and associated ductwork mains within the mechanical rooms. System air balance is to be accompanied with certified test forms as to obtained air quantities. Proper fan performance and coil discharge air temperature reading shall also be certified on test forms. G. Electrical power and controls power for the new mechanical systems. Confirm air handler and condensing unit power entry requirements and voltage for each prior to shop drawing phase and equipment order. H. Confirm thermostat locations with the agency prior to rough-in. Controls wiring shall be 120 volts or less. Provide transformers and relays as required to comply with this requirement. Conduit shall be steel conforming to the requirements of the Electrical Specifications, except as otherwise specified. I. RCI is the agency's 3rd party inspection company. Coordinate inspection timing with RCI and the agency. J. Smoke detectors to be installed upstream of the outside air duct connection to the return ductwork. Contact the existing fire alarm company to coordinate proper detector operation. K. Work must be performed AFTER normal work hours M-F 8:00am - 5:30pm, or on weekends. Coordinate work schedule with the Agency prior to commencing work