Renovation of a fire / police facility in Ocala, Florida. Completed plans call for the renovation of a fire / police facility.

The City of Ocala requires the services of a licensed State of FL building or general contractor to remodel and install electronic A/V equipment for the auditorium to support the Police Department. Bids received equal to or greater than $200,000 will require a Public Construction Bond for the total project amount Equipment: a. Projector: NEC NP-PA804UL-W-41, properly mounted to the ceiling and aligned to the screen. b. Cameras: three (3) AVer TR311HN, installed on the ceiling in marked locations, in combination with a camera controller, AVer CL01. c. Video mixer: Roland V-8HD installed and configured in a control room adjacent to the auditorium. d. Audio mixer: Behringer X32 Producer installed and configured in a control room adjacent to the auditorium. e. Streaming appliance: Tascam VSR-264 installed in a control room adjacent to the auditorium and configured to stream to OPD social media accounts. f. HDMI matrix switcher: Shinybow SB-5688Kp, installed and configured in a control room adjacent to the auditorium. g. main speakers: two (2) JBL CBT 70J-1 + 70JE-1, mounted on the front wall near the projection screen. h. Subwoofers: two (2) JBL Control SB2220, mounted on front wall in marked locations. i. Microphone system: three (3) each Shure BLX288/B58 and Shure BLX188/CVL, with receivers installed and configured in a control room adjacent to the auditorium. Additionally, one (1) Shure MX412S/S installed in a podium on the stage, connected to the mixer in the control room via XLR cable. j. Amplifiers: two (2) Crown XLi 2500, installed in a control room adjacent to the auditorium k. DSP/Feedback suppressor: dbx DriveRack PA2 installed and configured in a control room adjacent to the auditorium. l. Collaboration/presentation tool: Barco CX-50, installed and configured in a control room adjacent to the auditorium. m. Stage lights: eight (8) ADJ PAR829 lights, installed and connected to a Chauvet DJ OBEY4 in a control room adjacent to the auditorium. Lighting scenes are to be programmed for at least three (3) use cases/scenarios. o Construction/Fixtures: a. Stage: the current stage shall be enlarged to be 16" deeper than the existing stage. It must incorporate a step inside the new perimeter and must also incorporate a false floor to facilitate wiring and future expansion. The false floor must cover the entire stage, not just the new addition. b. Room lights: room lights are to be replaced with dimmable LED panels, with dimmers installed near the door to the training office, on the stage, and in the control room. c. Electrical needs: ten (10) standard 110v power outlets need to be installed on the walls. d. Carpet: carpet is to be replaced, including covering the new stage expansion. e. Furniture: twenty-four (24) tables measuring 11'8"x16"x28" along with two (2) tables measuring 7'x16"x28", all securely attached to an existing carpet-over-concrete floor. Additionally, two (2) freestanding tables measuring 4'x16"x28". f. A desk and 20u equipment rack in the control room adjacent to the auditorium. g. Wall graphics: the rear wall (approximately 42'x8') of the room is to be covered with vinyl graphics in a style to be coordinated with the PIO and training departments Formal Question Due By 11/7/2022 @ 5:00 PM EST