Renovation of an educational facility in Chicago, Illinois. Completed plans call for the renovation of a educational facility.

Dusable Boiler #1 Repairs -Replace Condensate Pumps-Only Pre-Qualified Various Trades Invited To Bid The proposal shall be submitted with the attached Bid Cover Sheet completed in its entirety. Warranty information, when applicable, shall also be included & submitted. All work to be performed during normal working hours. If bid price is over $25,000, you MUST submit a bid bond at time of bid. If bid price is over $50,000, you MUST submit a payment and performance bond if awarded a project. If bid price is over $10,000 or more, bidder must be signatory to relevant union, per terms of the Various Trades Contract and Project Labor Agreement. If bid price is over $75,000, you MUST include your MBE/WBE subs and relevant forms at time of bid. 1) Provide necessary labor and materials to replace the 12" main steam header valve for Boiler 1. 2) Provide necessary labor and materials to clean the tube holes and retube all two hundred and ninety (290) 2 1/2 " tubes in Boiler 1. 3) Provide necessary labor and materials to remove existing burner. 4) Provide labor and materials for supply and installation of new draft gas burner, mounting plate, and refractory/brick for Boiler 1. 5) Start burner to ensure proper operation. 6) Provide Boiler 1 Burner controls. 7) Include Instrumentation and control panel as needed. 8) Remove and replace safety switches, gaskets valves, and all additional items if found faulty. 9) Perform combustion tests and tune-up as needed. 10) Disconnect all boilers before work and re-connect to existing electric after completion. 11) Provide necessary labor and materials to perform Boiler 1 Trim as needed. 12) Test and ensure proper operation of Boiler 1 after all work has been completed. 13) Provide necessary labor and materials to disconnect and Remove (2) Existing Condensate Pumps. 14) Furnish and Install (2) New Centrifugal Condensate Pumps. 15) New Pumps to be 1.5" NPT Suction x 1.25" NPT Discharge with 2 HP 3 Phase ODP Motors. 16) Provide Piping Modifications to Accommodate New Pumps. 17) Test to Ensure Safe and Efficient Operations. 18) Perform Factory Start Up Upon Completion. 19) Provide necessary labor and materials to disconnect Piping and Electric from Existing Condensate Station. 20) Furnish and Install (1) New Duplex Condensate Return Pumping Station.