Renovation of a municipal facility in Winnipeg, Manitoba. Completed plans call for the renovation of a municipal facility.

The Work to be done under the Contract shall consist of replacement of overhead bridge cranes for City of Winnipeg Fleet Management maintenance buildings located at 195 Tecumseh Street and 215 Tecumseh Street. The funds available for this Contract are $290,000.00 (MRST included, GST extra). The major components of the Work are as follows: (a) The General Contractor shall survey the entire length of the crane runways to ensure proper clearances may be maintained for all motions and operations. (b) Clearance shall be maintained between the cranes and the building, as well as cranes operating at different elevations, under normal operating conditions. (c) Clearance shall be maintained between the cranes and the building, as well as parallel running cranes, under all normal operation conditions. (d) The overhead cranes shall include all hoists, bridge beams, end trucks and controls as specified herein. (e) The new cranes shall be installed on existing crane runway beams. (f) Crane components shall be prime painted then receive two coats of paint as specified. (g) The cranes shall be assembled in the manufacturer's plant according to manufacturer's standards. (h) After the new cranes are installed on the runway and before being placed in service, they shall be fully inspected and tested to ensure compliance with the applicable of the specifications and applicable standards. (i) The crane supplier shall include all assembly, field wiring, installation and starting up procedures. (j) The cranes shall be provided with all necessary lubrication fittings at all bearings, gears, etc.in accordance with crane manufacturer's recommendations. (k) Mechanical design includes bridge drives, gearing, bearings, bridge brakes, under running bridge wheels, bumpers and stops. (l) The bridge drives shall consist of motor or motors driving through a suitable reduction unit or units to the wheels located at each end of the bridges. (m) All electrical equipment, conduit and wiring shall be furnished as specified herein. (n) All bridges and trolleys shall be furnished with reversing control systems incorporating plugging protection. (o) Electrical equipment includes motors, brakes, controllers, resistors, protection/safety features. floor mounted pendant pushbutton stations, limit switches, runway conductor system, remote controls, wireless data exchange, collision avoidance system and LED lighting, as specified herein. (p) General Contractor to provide project closeout submittals of two (2) copies of the Operation and Maintenance manuals, as-built construction drawings describing the installation, electrification operation and maintenance of the cranes including product data spare parts information. (q) Final clean-up of all areas affected by the demolition and construction work. Official bid documents must be obtained from www.merx.com and bid submissions must be done through the Merx platform. award is subject to final approval.