Site work and renovation of an educational facility in Deatsville, Alabama. Completed plans call for the renovation of a educational facility; and for site work for a educational facility.

PLEASE NOTE: The estimated value listed for this project is for searchability purposes only and does not reflect the actual construction budget as determined by the owner. It should not be used for estimation purposes at this time. Plans and specifications are for viewing purposes only and in order to be considered an official bidder contractors must obtain plans and specifications from Goodwyn Mills & Cawood Inc. The Work of the project includes, but is not limited to, selective demolition, replacement of water line, miscellaneous site work, new fencing, and gravel driving pad at Thomasville Campus of ISTC; as specified and as indicated on the Drawings; coordination and supervision of the entire project; and all related work, as indicated in the Bid and Contract Documents. A cashier's check or bid bond payable to Ingram State Technical College in an amount not less than five (5) percent of the amount of the bid, but in no event more than $10,000, must accompany the bidder's proposal. Performance and statutory Labour and Material Payment Bonds, insurance in compliance with requirements, and verification of Verify enrolment (also with Proposals), will be required at the signing of the Contract. sets issued to each bidder submitting a bona fide bid, upon return of documents in good and reusable condition within ten (10) days of bid date. Other sets for general contractors, and sets for subs and dealers, may be obtained with the same deposit, which will be refunded as above, less cost of printing, reproduction, handling and distribution, which is estimated to be the same as the deposit amount. Partial sets will not be available. To expedite distribution of bid documents, deposit check(s) should be emailed and then mailed to Goodwyn Mills Cawood, LLC; Attn: Missy Lee; PO Box 242128; Montgomery, AL 36124 (emailed to: missy.lee@gmcnetwork.com). Bids must be submitted on proposal forms furnished by the Architect or copies thereof. All bidders bidding in amounts exceeding that established by the State Licensing Board for General Contractors must be licensed under the Provision of Title 34, Chapter 8, Code of Alabama, 1975, as amended, and must show such evidence of license before bidding or bid will not be received or considered by Architect or Owner; The bidder shall show such evidence by clearly displaying their current license number on the outside of the sealed envelope in which the proposal is delivered; Bidder must also include their current license number on the Proposal Form. This project is being bid EXCLUDING TAXES, and requires the Contractor comply with the requirements of Act 2013-205, which was signed into law on May 9, 2013. The Contractor and the Owner will be required to apply for Certificates of Exemption with the Alabama Department of Revenue which will handle administration of the Certificates. The Contractor shall account for the tax savings on the Proposal Form. Additional qualifications and requirements for General Contractor Bidders and separate Subcontractors and Manufacturers are indicated in the Bid and Contract Documents. The Owner reserves the right to reject any or all proposals and to waive technical errors if, in their judgment, the best interests of the Owner will thereby be promoted.