Renovation of a power facility in Tierra Amarilla, New Mexico. Working plans call for the renovation of a power facility.

: Proposals may also be submitted electronically by email in pdf format. All other requirements stated in the Solicitation Document remain in effect. Emails should be addressed to: lacbid@lacnm.us. Subject line of the email must contain the following information: RESPONSE RFP23-09 El Vado Fiber Optic Line. No Proposal may be withdrawn after the scheduled closing time for receipt of proposals. All forms of bribes, gratuities, and kickbacks are prohibited by state law. The selected contractor shall provide all labor, materials, and equipment to install and test approximately twelve (12) miles of new, 24-strand Single Mode (SM) fiber optic line per Exhibit E, El Vado Fiber Optic Line Specifications and Exhibit F, El Vado Fiber Optic Line Plan Set, as described below Project will begin at the EL Vado Hydroelectric Power Plant where the new fiber optic line will terminate in a new patch panel in the existing communications rack inside the plant control room located in the first underground level of the plant. The fiber optic line will be routed along the ceiling in a conduit and exit the building on the southeast through a newly cored penetration in the existing concrete powerhouse wall. The fiber optic line will be routed up a rigid riser attached to a 30' tapered steel pole. The overhead portion of the new fiber optic line begins at the new steel pole then extends overhead easterly for approximately 11.9 miles. The fiber optic line will be attached to an existing 69kV transmission powerline, which includes 162 existing 55-foot-tall wooden transmission poles along the path. The fiber optic line will come off the existing 69kV power pole just outside of the Spills Substation fence. The fiber optic line will transition to a new 50' wooden Class 2 "slack" pole near the fenced substation and then go underground again for the last (approximate) 180 feet. The underground duct bank will have two SCH-40 PVC conduits (1 spare) and two 3'x3'x3' pull boxes. The last section of the fiber optic line will leave the last pull box underground to the substation building, then transition through a vertical riser on the substation exterior wall, then penetrate the building and be routed along the ceiling through an existing cable tray. The new fiber optic line will terminate in a new patch panel in the existing communications rack inside the Spills Substation Building. The new fiber optic line will be tested but not placed into service.