Site work and paving for a road / highway in Waynesville, North Carolina. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Bidders and other interested parties should note that prequalification of equipment manufacturers by the Engineer prior to the bid opening may be required for this project. Equipment prequalification requirements, if any, are described in the Contract Documents. A certified check or cashiers check payable to The Town of Waynesville, or a satisfactory Bid Bond executed by a corporate surety licensed under the laws of North Carolina to execute such bonds in the amount equal to five percent of the total of the bid shall be submitted with each bid. The successful bidder shall be required to furnish separate, 100 percent Performance and Payment Bonds in compliance with North Carolina General Statutes Section 143-129 and of Article 3 of Chapter 44A. The Performance Bond shall be in full force and effect for one (1) year after the date of final acceptance of the project by the Owner. The bid deposit shall be retained by The Town of Waynesville if the successful bidder fails to execute the contract or fails to provide the required bonds, as stated above, within ten (10) days after award of the contract. Each bidder must be appropriately licensed as a Contractor in the State of North Carolina as provided in General Statutes Chapter 87. Each bidder must have a North Carolina Contractor's License. Each bidder shall make positive efforts to use small and minority owned business enterprises on this project. Attention is called to the fact that the Contractor must ensure that employees and applicants for employment are not discriminated against because of their race, color, religion, sex or national origin. The Town of Waynesville reserves the right to reject any or all bid proposals and to waive any informalities. The Town of Waynesville reserves the right to award a contract to the lowest, responsive, responsible bidder. The OWNER may make such investigations as they deems necessary to determine the ability of the BIDDER to perform the WORK, and the BIDDER shall furnish to the OWNER all such information and data for this purpose as the OWNER may request. The OWNER reserves the right to reject any BID if the evidence submitted by, or investigation of, such BIDDER fails to satisfy the OWNER that such BIDDER is properly qualified to carry out the obligations of the Agreement and to complete the WORK contemplated therein. A conditional or qualified BID will not be accepted. All applicable laws, ordinances, and the rules and regulations of all authorities having jurisdiction over construction of the project shall apply to the contract throughout. Each BIDDER is responsible for inspecting the site and for reading and being thoroughly familiar with the CONTRACT DOCUMENTS. The failure or omission of any BIDDER to do any of the foregoing shall in no way relieve any BIDDER from any obligation in respect to his BID. Defined Terms Terms used in these Instructions to Bidders which are defined in the Standard General Conditions of the Construction Contract (C 700)(2002 Edition) have the meanings assigned to them in the General Conditions. Certain additional terms used in these Instructions to Bidders have the meanings indicated below which are applicable to both the singular and plural thereof. 1.1. Bidder - one who submits a Bid directly to Owner as distinct from a sub-bidder, who submits a bid to a Bidder. 1.2. Issuing Office - the office from which the Bidding Documents are to be issued and where the bidding procedures are to be administered. The Issuing Office for this project is Civil Design Concepts, PA., 168 Patton Ave, Asheville, NC 28801. 1.3. Successful Bidder - the lowest, responsible and responsive Bidder to whom Owner (on the basis of Owner's evaluation as hereinafter provided) makes an award. 2. Copies of Bidding Documents 2.1. Complete sets of the Bidding Documents in the number and for the cost, if any, stated in the Invitation to Bid may be obtained from the Issuing Office. 2.2. Complete sets of Bidding Documents must be used in preparing Bids; neither Owner nor Engineer assume any responsibility for errors, omissions, or misinterpretations resulting from the use of incomplete sets of Bidding Documents. 2.3. Owner and Engineer in making copies of Bidding Documents available on the above terms do so only for the purpose of obtaining Bids for the Work and do not confer a license or grant for any other use. 3. Qualifications of Bidders To demonstrate qualifications to perform the Work, each Bidder must be prepared to submit within five days after Bid opening upon Owner's request, written evidence such as financial data, previous experience, present commitments, and other such data. The Owner reserves the right to reject any Bid if the evidence submitted by, or investigation of, such Bidder fails to satisfy the Owner that such Bidder is properly qualified to carry out the obligations of the Agreement and to complete the Work contemplated therein. Each Bid must contain evidence of Bidder's qualification to do business in the state where the Project is located or covenant to obtain such qualification prior to award of the contract. Examination of Contract Documents and Site 4.1. It is the responsibility of each Bidder before submitting a Bid: 4.1.1. To examine thoroughly the Contract Documents and other related data identified in the Bidding Documents (including "technical data" referred to below); 4.1.2. To visit the site to become familiar with and satisfy Bidder as to the general, local and site conditions that may affect cost, progress, performance or furnishing of the Work; 4.1.3. To consider federal, state and local Laws and Regulations that may affect cost, progress, performance or furnishing of the Work; 4.1.4. To study and carefully correlate Bidder's knowledge and observations with the Contract Documents and such other related data; and 4.1.5. To promptly notify Engineer of all conflicts, errors, ambiguities or discrepancies which Bidder has discovered in or between the Contract Documents and such other related documents. 4.2. Reference is made to the Supplementary Conditions for identification of: 4.2.1. Those reports of explorations and tests of subsurface conditions at or contiguous to the site which have been utilized by Engineer in preparation of the Contract Documents. Bidder may rely upon the general accuracy of the "technical data" contained in such reports but not upon other data, interpretations, opinions or information contained in such reports or otherwise relating to the subsurface conditions at the site, nor upon the completeness thereof for the purposes of bidding or construction. 4.2.2. Those drawings of physical conditions in or relating to existing surface and subsurface structures (except Underground Facilities) which are at or contiguous to the site that have been utilized by Engineer in preparation of the Contract Documents. Bidder may rely upon the general accuracy of the "technical data" contained in such drawings but not upon other data, interpretations, opinions or information shown or indicated in such drawings or otherwise relating to such structures, nor upon the completeness thereof for the purposes of bidding or construction. 4.3. Information and data shown or indicated in the Contract Documents with respect to existing Underground Facilities at or contiguous to the site is based upon information and data furnished to Owner and Engineer by owners of such Underground Facilities or others, and Owner and Engineer do not assume responsibility for the accuracy or completeness thereof unless it is expressly provided otherwise in the Supplementary Conditions. 4.4. Provisions concerning responsibilities for the adequacy of data furnished to prospective Bidders with respect to subsurface conditions, other physical conditions and Underground .