Renovation of a medical facility in Sacramento, California. Completed plans call for the renovation of a medical facility.

Solicitation Number: I-001095, M-022A, I-001091, M-006A Please read the Request for Quotation and any revisions in their entirety as they contain information pertinent to the bidding process. Note, CDCR is only soliciting certified small/micro businesses for this purchase. All Roofing membrane, membrane flashings, detail Membrane 24''x50' G410 white strip 8''X 100' (67 sf roll), All extruded polystyrene roofing insulation (XPS), tapered insulation, crickets insulation, vapor barrier retarder, gypsum 1/2" Inch minimum thickness cover boards (preprimed), plumbing roof vents flashings, metal support flashing, coping, scuppers, foil face tape, termination tapes, fasteners, Roof Insulation Board Adhesives, membrane adhesive, anchors, termination bars, protection walk pads, equipment work pads, pipe flashings, preprimed barrier boards, stainless steel pipe clamps. A. General: 1. See Product descriptions in this specification section for detailed information and requirements for each component listed below. 2. All proposed roof assemblies must be FMG approved and have an approved current RoofNav report and assembly number. See "Submittals" article herein. 3. All proposed roof assembles must meet all requirements specified in this specification section. 4. Roof insulation must be XPS (extruded polystyrene). EPS (expanded polystyrene and Polyiso (polyisocyanurate) insulations are not acceptable. 5. All roofing must be fully-adhered systems unless noted otherwise. B. Roof System 3: Location: Building 1. 21.02 - RJ Donovan Correctional Facility (RJD). 2. 24.01 - California State Prison, Corcoran (COR). 3. 24.02 - California State Prison, Corcoran (CPR) 4. 32.01 - California State Prison, LA County (LAC). 5. 32.02 - California State Prison, LA County (LAC). 6. 41.00 - Salinas Valley State Prison (SVSP). 7. Components: a. Single-ply PVC roofing, minimum 0.080 inches thick. b. Cover board. c. XPS insulation. d. Vapor retarder. e. Concrete deck. 8. Acceptable Manufacturers: The following manufacturers will be acceptable if they meet all ofthe requirements and criteria in this specification section. a. Sika Sarnafil; RoofNav Assembly Number 97158-0-0. b. IB Roof Systems, RoofNav Assembly Number 356667-0-0. c. Versico Roofing Systems; RoofNav Assembly Number 401994-0-0. d. Carlisle; RoofNav Assembly Number 401994-0-0. e. Environmental Roofing Components; RoofNav Assembly Number 302372-0-0. f. Pro-Link Roofing Systems; RoofNav Assembly Number 302372-0-0. g. For manufacturers/assemblies not listed, comply with substitution requirements in Section 01 25 00 - Substitution Procedures.