Site work and paving for a road / highway in Laurinburg, North Carolina. Completed plans call for site work for a road / highway; and for paving for a road / highway.

The purpose of this Special Provision is to carry out the North Carolina Department of Transportation's policy of ensuring nondiscrimination in the award and administration of contracts financed in whole or in part with State funds. The work covered by this provision consists of clipping high shoulders and reconstructing the earth shoulder in accordance with Standard Drawing No. 560.01 and 560.02 of the Roadway Standard Drawings with the following exceptions: the width will be shown on typical sections, or to the existing shoulder point, whichever is nearer, as long as the desired typical is achieved. Seeding and mulching shall be performed upon completion of shoulder grading when earth borrow is used. This work shall be performed immediately after the resurfacing operations are complete as directed by the Engineer. The Contractor's attention is directed to the fact that there are areas of existing pavement on this project that will require repair prior to resurfacing. Patch the areas that, in the opinion of the Engineer, need repairing. The areas to be patched will be delineated by the Engineer prior to the Contractor performing repairs. The North Carolina Department of Transportation will administer a custom version of the Federal On-the-Job Training (OJT) Program, commonly referred to as the Alternate OJT Program. All contractors (existing and newcomers) will be automatically placed in the Alternate Program. Standard OJT requirements typically associated with individual projects will no longer be applied at the project level. Instead, these requirements will be applicable on an annual basis for each contractor administered by the OJT Program Manager. On the Job Training shall meet the requirements of 23 CFR 230.107 (b), 23 USC - Section 140, this provision and the On-the-Job Training Program Manual. The Alternate OJT Program will allow a contractor to train employees on Federal, State and privately funded projects located in North Carolina. However, priority shall be given to training employees on NCDOT Federal-Aid funded projects. Project No - 2023CPT.08.10.20471 , 2023CPT.08.10.20831 1 Section of Us-501, and 3 Sections of Secondary Roads Contract Id:C204826 WBS: 2023cpt.08.10.10831, Etc County: Scotland, Hoke Length: 10.452 MI Job Type: Milling, Resurfacing, and Shoulder Reconstruction. A Bid Bond or Bid Deposit in the Amount of 5% of the Total Amount Bid Will Be Required. The Bidder Shall Submit an Electronic Bid Bond With Each Electronic Bid Submittal Unless They Elect to Furnish a Bid Deposit. All Questions Related to Projects During the Advertisement Period Shall Be Emailed to the State Contract Officer at Contractofficer@ncdot.gov. The Minimum Wage for Labor Will Be Shown in the Proposal Form for Federal Aid Projects. Contractor's License: a General Contractor's License Is Required in Order to Submit a Bid on Any Non-federal Aid Project Where the Bid Is $30,000.00 or More, Except for Certain Specialty Work as Determined by the Licensing Board. On Federal Projects, the Appropriate Contractor's License Shall Be Obtained Within 60 Days of Bid Opening. For Additional Information or to Make Application for a License, Visit the Contrator Licensing Board Prequalifying to Bid: All Prospective Bidders Shall Be Prequalified With the Department of Transportation Prior to Submitting a Bid. Contractors Who Are Not Prequalified May Obtain Information and Forms for Prequalifying From the Prequalification Section of the Contract Standards and Development The Department of Transportation Hereby Notifies All Bidders That It Will Affirmatively Ensure That in Any Contract Entered Into Pursuant to This Invitation to Bid, Minority Business Enterprises Will Be Afforded Full Opportunity to Submit Bids in Response to This Invitation and Will Not Be Discriminated Against on the Grounds of Race, Color, Sex, or National Origin in Compensation to This Award. The Right Is Reserved to Reject Any or All Bids. NCDOT - 001 - Milling, Resurfacing, and Shoulder Reconstruction.