Site work for a water / sewer project in Houston, Texas. Completed plans call for site work for a water / sewer project.

The deadline to ask questions is 2/13/2023 1:00 PM CST Proposals must be submitted enclosed in a sealed envelope and plainly marked on the outside clearly identifying the proposal as "Bid PW 23-02". Proposals will be judged based on the BEST VALUE for the City pursuant to the evaluation criteria listed in the bid specifications. Historically Underutilized Businesses (HUBs) are encouraged to submit a proposal. Each proposal must be received before the stated time on the day the proposals are due. The City shall not be responsible for any verbal communication between any employee of the City and any potential firm. Only written requirements and qualifications will be considered. If you have specific questions concerning the bid documents, the scope of work, or the Project, please submit on Civcast. The City of West University Place reserves the right to reject any and all proposals, to waive irregularities, and to accept the proposal deemed the most advantageous to the City. The City has completed an inspection of the existing well to determine rehabilitation required. To date, pump and column assembly have been removed from the well, the well has been wire brush cleaned, and a pump report has been prepared. A survey was completed after the wire brush cleaning. The following recommendations were made and will be required by this contract: 1. Furnish and install 20-inch diameter x 5-foot long 304 stainless steel swage patch at a depth of 685' including material, labor, supervision, testing and appurtenances. 2. Televise the well, post swage patch installation with a color camera with side-look view and provide a written report. 3. Disinfect well and perform bacteriological sampling 4. Furnish and Install one (1) Vertical Turbine Well Pump Rated for a Capacity of 1,600 GPM at a Total Dynamic head of 520-Ft with a 10" x 3" x 1-15/16" x 580' setting, including but not limited to reinstallation of existing motor and installation of new pump and inner assembly consisting of new column pipe, oil tubing, lineshaft, bearings, centralizers, and couplings, complete in place.