Renovation of a medical facility in Iowa City, Iowa. Completed plans call for the renovation of a 140-square-foot medical facility.

This project will expand the Reception Desk in Clinic D of the Clinical Cancer Center.project consists of but is not limited to, renovation of approximately 140 sf on level 3 of the pomerantz family pavilion. included in the project is addition of (1) check-in desk to existing cancer clinic d reception and required ceiling, wall and finish modifications. mept scope of this project involves the work required to add the additional check-in desk including all power and data to serve the desk as well as the work pertaining to the floor plan revisions including sprinkler, hvac, and lighting adjustments. door to the check-in desk and its associated access control will be relocated, too. existing adjacent spaces will remain occupied and used by the hospital as their intended health care services. All work shall be performed by well-qualified and licensed mechanics with a thorough knowledge of the various systems involved in this building. It shall be this contractor's responsibility to see that their mechanics are familiar with all the various codes and tests applicable to this work. B. All equipment shall be new and of the type as specified by the engineer unless otherwise noted in these specifications or on the drawings to remain and or be reused. C. The intent of the drawings and specifications is for complete installation of the systems outlined in the drawings and specifications so that at the conclusion of construction the system will be turned over to the owner complete and ready for safe and efficient operation. D. This contractor shall be required to furnish and install all such items normally included on systems of this type, which, while not mentioned directly herein or on the drawings are obviously essential to the installation and operation of the system and which are normally furnished on quality installation of this type. The drawings and specifications cannot deal individually with the many minute items that may be required by the nature of the systems. E. If there is a discrepancy between the drawings and specifications or within either document itself, the more stringent requirements shall be estimated unless an addendum is issued for clarification. F. The HVAC Contractor shall establish system elevations prior to fabrication and installation. The HVAC Contractor shall coordinate elevations with other trades. All elevations shall be coordinated with all trades in the field prior to installation. When a conflict between trades arises, the design team shall be notified immediately prior to further installation however priority shall be as follows: 1. Lighting Fixtures 2. Gravity flow piping, including steam and condensate. 3. Electrical bus duct. 4. Sheet metal. 5. Cable trays, including access space. 6. Other piping. 7. Conduits and wireway