This is a service / maintenance or supply contract in Midway, Kentucky. Contact the soliciting agency for additional information.

Mow and trim the fine turf lawn area of the Carter County Welcome Center located on I-64 Westbound (Milepoint 173.587) consisting of approximately 3.5 acres per cycle and the Carter County Rest Area located on I-64 Eastbound (Milepoint 174.001) consisting of approximately 3.8 acres per cycle. The quantity identified on this line represents 7.3 acres to be mowed per mowing cycle with an estimate of 25 mowing cycles per season. This would equate to approximately 182.5 acres. The number of cycles per season may vary up or down depending upon weather conditions and will be determined by the Department. Perform the mowing operation with commercial grade turf type mowing equipment not less than 48" and not more than 72" in width. A small push type mower may be utilized for trimming. Farm tractors with rotary finish mowers will not be allowed. Mow the grass to a minimum height of 3". Correct any uneven or streaked mowing immediately. The Department will direct the time and place for mowing to begin. If a mowing cycle is delayed because of weather conditions or other problems that results in a build up of grass clippings (bio-mass), remove or disperse the clippings over the area to eliminate unsightly build-up of debris and to prevent the smothering of the turf. Perform trimming operations after each mowing cycle. Perform trimming operations around mulched areas, trees, picnic table pads, trash containers, curbs, sign posts or other obstacles located on the grounds. Blow or sweep clippings off of all concrete surfaces after trimming is completed. Perform trimming along concrete edges as needed to keep all growth from encroaching over the sidewalks, curbs, picnic pads and other concrete areas. Utilize a hand-held string trimmer or power edger to perform the trimming operation. The use of herbicides will not be used to keep the growth from the sidewalks or curbs with the exception of those areas where there is growth in cracks (Refer to Line 0003 for products and procedures).