Renovation of a library in Clinton, Connecticut. Completed plans call for the renovation of a library.

The Town Manager reserves the right to reject any, or any part of, or all proposals; to waive informalities and technicalities and to accept the Bid which the Town deems to be in the best interest of the Town, whether or not it is the lowest dollar amount. Project Location:10 Killingworth Turnpike Clinton, CT 06413 Question Deadline 03/16/2023 Only questionssubmitted by e-mail will be addressed to: Please submit all questionsto: Todd Hajek thajek@clintonct.org and a copy to Mary Schettino mschettino@clintonct.org Removal of wet insulation (where indicated), System repairs, Surface preparation and Installation of a restorative two-part polyurea liquid membrane coating with reinforcement. SUMMARY OF WORK- SPECIFIC: EPDM ROOF SYSTEM RESTORATIONS 1. Adhere to all OSHA safety measures and requirements. 2. Repair roof and close all open conditions in preparation to receive the restorative liquid membrane. a. All necessary field and flashing repairs must be done according to good construction and roofing practices b. All seams must be checked and any loose or damaged seams must be reseamed/repaired. 3. Remove and replace in kind any specified areas of wet or compromised insulation with proper tie-ins. a. Cut out all areas of wet/damaged insulation down to the decking or older roofing system. (Approx. area: 8x8' as shown on the drawings) 1) Core Results: a) Metal Steel Decking b) 2" Polyiso c) (2) 1/2 " Fiberboard d) .060 EPDM Fully adhered 4. Pressure wash and scrub entire roof and flashings using a stiff brush and solution of Simple Green or TSP cleaners with water as specified. 5. Rinse roof and flashings using clean water and pressure washer to remove all cleaning solution residue, repeat the rinsing process until no cleaning solution is left and allow drying 24 to 48 hours a. Note: If any cleaning solution residue is left on the area to be coated it will not stick. This condition typically occurs around the internal drains. b. Roof must be 100% dry prior to application 6. Start with drains, flashings, including walls and curbs before proceeding to field installation. Apply a base coating of LiquiTec TC (White in color) at 3.0 gal./100 sq. ft. over single-ply roof surface. Use a 1/4 " notched squeegee, where applicable, to spread coating and roller to apply for uniform minimum coverage. 7. Immediately embed 40" wide Grip Polyester reinforcement into wet coating by rolling over the fabric surface to fully saturate and encapsulate, ensuring no wrinkles, voids or vertical fibers. 8. Lap rolls of reinforcement a minimum of 3 in. (75 mm) on end and side laps. Roller must be fully saturated with coating when backrolling over the reinforcement scrim to wet it out completely. a. Note: Allow to cure thoroughly, but no more than 48 hours. 9. Apply a top coating of LiquiTec BC (Grey in color) over the basecoat at 2.0 gal./100 sq. ft. 10. Contractor is responsible for securing materials. 11. Contractor to supply 2-year workmanship warranty. 12. Manufacturer to supply one long-term system warranty directly to owner. 13. Contractor responsible for obtaining building permit. 14. A protective roof covering path must be used to transport material across the roof. 15. Clean up and properly dispose of all debris and repair any damage done to grounds, building or roof top Bid Results 15YR GOLD SEAL ROOFING - $124,400.00 20YR GOLD SEAL ROOFING - $174,500.00