Site work, paving and outdoor lighting for a mixed-use development in Millbrae, California. Completed plans call for site work for a road / highway; for outdoor lighting for a road / highway; for paving for a road / highway; sidewalk / parking lot; and water / sewer project.

Q&A Deadline-03/30/2023 2:00 PM (PDT) Online Q&A-Yes Bid Bond-10.00% Payment Bond-100.00% Performance Bond-100.00%.A certified check or corporate surety bond of not less than ten percent (10%) of the amount bid for the total cost of the project must accompany each proposal. The physical bond/check must be provided to the city and mailed to the attention of: Bill Giang, Assistant Engineer, 621 Magnolia Avenue, Millbrae, CA 94030 within two (2) business days after bid opening. Scope Of work: The project consists of the upsizing approximately 1,800 linear feet of an existing 6-inch vitrified clay pipe to 8-inch-high density polyethylene pipe using the pipe bursting and open-cut/trenching method, reconnection of existing sewer laterals, and sewer manhole rehabilitations. Additionally, approximately 1,700 linear feet of new 8-inch water main will be installed in the roadway area (existing water main at the existing back of walk) which will include installation of valves, fittings, thrust blocks, as well as reconnection of the existing meter and hydrant laterals to the new main line. This project includes street light improvements which include installation of street light foundations, poles, LED fixtures, and pull boxes as well as running new conduit and wire within the roadway. Finally, the approximately 1,600 linear foot segment of Ahwahnee Drive shall undergo pavement rehabilitation, including grinding of existing pavement, recompacting the existing aggregate base/subbase, installing hot mix asphalt, constructing ADA curb ramps, sidewalk, curb, and gutter. The goal of these following requirements is to prevent the pollution of storm water runoff on construction projects by keeping pollution out of storm drains and creeks, reducing the exposure and discharge of materials and wastes to storm water, and by reducing the erosion and sedimentation. Storm drains discharge runoff directly to creeks and the bay without treatment. A. Install erosion control measures (silt fence and erosion control matting) where shown on plan (or as directed in the specifications for the various items of work) to prevent sediment-laden runoff from migrating into creeks and public storm drain system. B. Prohibit illicit discharge (non-rainwater) into the storm drain system. C. Construct, inspect and maintain any and all necessary systems to eliminate contaminants from entering the storm water system. D. Clean up and control of work site materials, spoils and debris. E. Removal of contaminants produced by the project. F. After job completion, removal of systems installed by the Contractor to control contaminants from entering the storm water system. G. The work shall include the provision of all labor, materials, equipment and apparatus not specifically mentioned herein or noted on the plans, but which are incidental and necessary to complete the work specified.