Site work for a power facility in Henderson, Kentucky. Completed plans call for site work for a power facility.

The City of Henderson reserves the right to reject any and all bids and to waive irregularities in said bids. The fence work being done will connect with existing fencing shown in the attached file, Madison St Station Fence Layout, and the new fence must follow the listed fence spec in the bid. The work will include the removal of existing fence and gate to be replaced. Ensure that the costs for removal are included in the bid Technical questions may be directed to Tim Clayton, Gas System Director at 270-831- 4918. Bid procedure questions may be directed to Dawn Winn, Assistant Finance Director, at 270-831-1200. Items for bid contained herein shall remain subject to compliance with Buy American Provisions. Fence Specifications Fabric: 84" 9 GA. Aluminized (2" Mesh) CHAIN LINK FABRIC. Top Rail: 1 5/8" O.D. DQ-40 PIPE, 1.83 lbs. per foot. Top Rail 21' in length, joined with 1 5/8" Sleeve Line Post: 2 3/8" O.D. DQ-40 PIPE POST, 3.11 lbs. per foot. Line Posts set 10' on center maximum spacing. Concrete footing: 10" Diameter. 36" Depth Terminal Post: 2 7/8" O.D. DQ-40 PIPE POST, 4.64 lbs. per foot. Concrete footing: 12" Diameter, 36" Depth Bracing: Terminal posts braced and trussed to the nearest line post with 1 5/8" O.D. DQ-40 Pipe and 3/8" Truss Rod & Truss Rod Tightener. Tension Wire: 7 GA. Coil Spring Aluminized Tension Wire attached to bottom of fence fabric with 9 GA. Aluminum Hog Ring Spaced 24" on center. Barbed Wire: 3 Strands of 12 1/2 GA. 4 PT. Aluminized Barb Wire on 45 Deg Pressed Steel Barbed Wire Arm SPECIAL CONDITIONS AND TECHNICAL SPECIFICATIONS Page 2 Fittings: Regular Brace Band & Carriage Bolt. Pressed Steel, Rail-end, 45 Deg. Pressed Steel Barb Wire Arm, Pressed Steel Cap, 3/16" X 3/4 " Tension Bar, Regular Tension Band & Carriage Bolt. Tie Wire: 8 1/4 " 9 GA. E-Z Aluminum Tie Wire Spaced 15" on Center for Line Posts & 24" on Center for Rails Post Footing: Truck Poured Concrete Bid Scope A: Madison Street Station - 1901 Madison Street The fence work being done will connect with existing fencing shown in the attached file, Madison St Station Fence Layout, and the new fence must follow the listed fence spec in the bid. The work will include the removal of existing fence and gate to be replaced. Ensure that the costs for removal are included in the bid. The scope for the location is 943 Length Feet of fence. B: Pratt Reg Station - 6303 Hwy 425 The fence work being done will surround two meter sets on Pratt Paper Property. The layout of the fence is shown in the attached file, Pratt Reg Station Fence Layout. The area is a 60' X 100' lot that will have 1 Gate Panel x 4' 6" WD and 2 Gate Panels x 7' 6" WD. The fence and gate must follow the listed fence spec in the bid. C: Sand Lane Station Fence - 1300 S Elm Street The fence work being done will be the repair of existing fence and gate. 130 feet of barbed wire on 45 deg Pressed steel barbed wire arm needs to be replaced on the side of this fenced lot. The 2 Gate Panels X 7' 6" WD must be replaced including the support terminal poles and all the fittings. These repairs must follow the listed fence spec in the bid.