Demolition, site work, renovation and addition to a municipal facility in Trenton, New Jersey. Completed plans call for the addition of a municipal facility; for the demolition of a municipal facility; for the renovation of a municipal facility; and for site work for a 960-square-foot municipal facility.

Project No: A1380-00 - 5TH Floor Alterations All Bidders Are Urged to Limit the Number of Representatives to Attend the Pre-bid Meeting in Order to Keep the Number of Attendees to a Minimum in Order to Comply With Covid-19 Related Social Distancing Guidelines. All Attendees Must Wear Face Mask Coverings. Single Bid (lump sum all trades) General Construction (C008) or General Construction / Alterations & Additions (C009) A company check payable to the "Treasurer, State of New Jersey" is required. Contact Anthony Mangine at Anthony.Mangine@treas.nj.gov for further information. Mailing address is as follows: Regular Mail (DPMC, P.O. Box 034, Trenton, NJ 08625) or Overnight Mail (DPMC, 33 West State St, 9th Fl, Trenton, NJ 08608). Bidders must be classified by the Division under N.J.S.A. 52:35-1 et seq and must submit bid security as provided in Instructions to Bidders and General Conditions, Revised December 2015. No bidder may withdraw his bid for 60 calendar days after the opening. The State may reject any and all bids. Bidders are required to comply with the requirements of N.J.S.A. 10:5-31 et seq. and N.J.A.C. 17:27. Project Location: Capital Place One, 202-222 South Warren Street, Trenton, NJ 08611 1. All work will be performed on the 5th Floor of Capital Place One. 2. Construct new partitions to create a separated corridor between the core of the building and tenant spaces on one side of the floor. To avoid relocating and/or additional lighting, diffusers, sprinkler heads, etc., the dividing wall will be held down 18-inches below the ceiling. 3. Provide new doors, frames and hardware to allow for future access control that will be designed, permitted and installed by others. 4. Provide a new transaction window with paper pass-thru capability. 5. Create a new office by installing a new partition within an existing office. A new door, frame and hardware will be specified