Renovation of a water / sewer project in Baytown, Texas. Completed plans call for the renovation of a water / sewer project.

Items or services: Purchase of two (2) new 50,000 GPM Centrifugal pumps, motors, associated components in accordance with CWA's written specifications. Should you have any questions or comments regarding the Bid Documents or desire to make a site visit, contact David Miller, at (832) 347-4208. Work of the contract is for direct purchase of two new 50,000 gpm centrifugal pumps and appurtenances for the Lynchburg Pump Station located at 908 Independence Pkwy N., Baytown, TX 77520. B. Bid Item No. 1 shall consist of the following: 1. Design, manufacture, fabrication, assembly, painting, and finite element analysis for two (2) vertical centrifugal pumps, Pump Nos. P201 and P206, including new suction bells, intake butterfly valves, harnessed couplings, and suction tubes. 2. Design and detail gland water system. Provide all equipment (i.e. automatic self-cleaning strainer, booster pump, valves, solenoids, blocks, eductors, instrumentation, electrical panels). General Contractor will install and provide interconnecting process piping, conduit, and wire. 3. Design and detail oil lubrication system. Provide all equipment (i.e. reservoirs, flow control valves, filters, heat exchangers, electrical panels). General Contractor will install and provide interconnecting process piping, conduit, and wire. 4. Vibration monitoring system. 5. Design, detailing and fabrication of walkways and ladders. General Contractor will install. 6. Factory witness testing of the pumps with job motors, and factory adjustable speed drive. A separate teste will be run for calibration of a 36-inch magnetic flow meter (provided by the General Contractor). 7. Shipping preparation for pumps and motors, shipping to Lynchburg Pump Station, and receiving inspection of the equipment at the site. General Contractor will offload equipment and store per manufacturer's instructions. 8. Startup and testing including services of a Pump Manufacturer representative. 9. Training and Warranty C. Bid Item No. 2 shall consist of the following: 1. Design, manufacture, fabrication, assembly, painting, and witness factory test of two (2) medium voltage synchronous motors, accessories, and appurtenances for Pump Nos. P201 and P206. 2. Vibration monitoring system. 3. Furnish all special tools and spare parts; disassembly (if required), handling, delivery and unloading at the Pump Manufacturer's test facility, final assembly of motors: all preparatory work to place the motors on the test stand including any special appurtenances needed for temporary testing location, installation of the motors on the driven equipment; testing. 4. Furnish all special tools and spare parts; disassembly (if required), handling, and delivery to the Lynchburg Pump Station, final assembly of motors; all preparatory work to place the motors in final location on the motor deck; motor foundations; anchor bolts and sole plates. 5. Installation of motors in the final location, accessories and appurtenances will be by the General Contractor under direct supervision of motor manufacturer.; all field painting and coating will be by the General Contractor. 6. Startup and testing including services of a Motor Manufacturer representative. 7. Training and Warranty