Site work and paving for a road / highway in Tualatin, Oregon. Completed plans call for site work for a road / highway; and for paving for a road / highway.

IDENTIFICATION OF PROJECT: Major items of work consist of 3,033 tons of asphalt with fiber reinforcement, 2,036 square yards of full depth patch, 8,372 square yards of cold plane, and 27 ADA ramp improvements. RIGHT OF REJECTION: The City of Tualatin reserves the right to reject any bid not in compliance with all prescribed public procedures and requirements, and may reject for good cause any or all bids upon a finding that it is in the public interest to do so. Bids cannot be withdrawn within thirty days (30) after the Bid Closing. The City reserves the right to make changes to the Invitation to Bid and the Contract Documents by written addenda prior to the Bid Closing. Addenda shall be made available to all contractors who have purchased a copy of the Contract Documents, as provided in the Contract Documents. For additional information, contact Bert Olheiser at 503-691-3096. Perform the following work as specified or as marked on the street by the Engineer. The Contractor shall pursue the work vigorously to completion. Once started, there shall be daily progress until the street pavement, including temporary pavement marking is finished and normal traffic is resumed. Work sequencing shall be as follows: 1. Obtain approval of work schedule, mix design, striping materials, and traffic control plan 7 days prior to beginning work. 2. Install signs and notify agencies and residents as specified in Section 302 of these Technical Specifications. 3. Install erosion control measures prior to start of project work. 4. Maintain traffic per Section 302 of these Technical Specifications. 5. Perform full depth patching as shown on plans or as marked in the field. 6. Sawcut and Grind along lines shown on plans or as marked in the field, including curb edge transitions and end tapers. 7. Note any required warping of pavement at proposed curb ramps to create slopes <5% at the gutter. Obtain approval from Engineer prior to paving. 8. Remove all remaining legends and striping by hydro blasting. 9. Place Asphalt Overlay or Inlay