Site work and renovation of a sidewalk / parking lot in Kansas City, Missouri. Completed plans call for the renovation of a sidewalk / parking lot; and for site work for a sidewalk / parking lot.

Parking Lot B - 112 ft. x 167 ft. Parking Lot A - 171 ft. x 267 ft. 1) Contractor shall include all costs associated with the mobilization of their labor, materials, tools and equipment to the jobsite. This shall include all project management, travel expenses and ancillary expenses required to complete the scope of work as described herein. Contractor shall be responsible for monitoring all tools during the course of this project. 2) Work to be done during a weekend. Work to start on a Friday after 6:00 PM and completed on Sunday by 6:00 PM and shall be in compliance with the latest industry standards. Date options are as follows: June 16-19, 2023, September 1-4, 2023, November 10-12, 2023 or November 24-26, 2023. NOTE: Family Court will be closed on June 19, September 4, November 10 and November 24, 2023. 3) Family Court prefers all work to be done in one mobilization. However; if needed, Parking Lot A can be done on one weekend and Parking Lot B done on another weekend. 4) Contractor shall mill the existing asphalt in both parking lots at a depth of 2 inches [use the perimeter cold planer process to mill the existing asphalt beside all concrete curbs and concrete entryways as this process will insure the new pavement is level with all concrete curbs and entryways]. NOTE: Any asphalt curbs shall be resurfaced as well. 5) Contractor shall complete necessary preparation by cleaning existing asphalt free of dust, dirt and debris using industrial blowers and brooms. All debris to be removed and legally disposed of off-site. 6) Contractor shall furnish and spray SS1H TAC coat so old asphalt can properly bond to new asphalt. NOTE: Any pot holes or low-lying areas shall be filled prior to resurfacing. 7) Contractor shall furnish and install a single layer of surface course asphaltic concrete to measure 2 inches thick to Parking Lot A [approximately 45,657 sq. ft.] and Parking Lot B [approximately 18,704 sq. ft.] and should be the APWA Type 3-01 (this mix can be recycled as long as it meets latest Industry Standards). 8) Contractor shall use a pneumatic rubber tire steel roller for better compaction, a smoother surface and a longer lasting pavement life. 9) Contractor shall repaint (strip) the parking spaces as per the existing marked parking spaces in both lots and reset existing wheel stops in Parking Lot A in existing space locations.