Renovation of a residential development in Garland, Texas. Completed plans call for the renovation of a residential development.

** As per Alex Arellano project was awarded to Phillips Stim and Construction LLC for $21,350** Remove cabinetry from above bathtub prior to demolition, not to be replaced. Remove existing Bath Tub and replace with low profile shower base with curb and ceramic tile surround. Remove all existing wall material from existing walls around bathtub area. Expose wood studs and notify CDD if wall studs are damaged or rotted prior to replacement. Add supports to the opened wall for handicap hand railings on the two sides and lateral handicap bar on showers supply side to support a hand held shower slide bar. Drain will need to be relocated to fit new unit at center of floor base. Shower Base to be poured concrete and tiled, with masonry shower seat. Install all new fiber cement board to existing wall shower area and waterproof according to manufacturer's installation requirements. Install ceramic tile and soap dish of matching color as chosen by the home owner and signed off on the color selection form prior to order. Install with thin set mortar. Grout wall with latex-Portland grout and apply mildew resistant caulk to all seams, fixtures and pipe penetrations. All tile and grout work must be properly sealed after installation. Contractor shall supply and install a grab bars with a gripping width of 1 1/4" to 1 1/2" in diameter, stainless steel, with a spacing of 1 1/2" clearance from existing walls, cover each shower wall. They shall be properly secured to wall studs as per manufacturer's installation recommendations. Installation is on frame wall, secure bar tightly to studs. Supply and install a diverter conversion fitting and hand held system, consisting of holder and spray head attached to a 5 foot coiled stainless steel wrapped hose. Include an adjustable clip to secure the shower head to slide on the support bar installed. A sealed written request made to prospective suppliers requesting submission of a bid for goods or services.Sealed bids have a state mandated dollar level. All documents (forms) herein and attached are required to be completed and returned with response. All questions must be answered within the Ion Wave Question & Answer segment. No emailed, faxed or phone call question related to this bid will be responded to. The deadline for submitting questions on this bid is May 3, 2023 at 12:00 p.m. (noon). Vendors must submit a bid on all items. NO partial bids will be accepted, and will be deemed non responsive. Mark Outside of Envelope: RFB 0760-23 Single Family Rehabilitation 1017 Brookshire Circle