Site work and outdoor lighting for a mixed-use development in Wolfeboro, New Hampshire. Completed plans call for site work for a bridge / tunnel; for outdoor lighting for a bridge / tunnel; sidewalk / parking lot; and sidewalk / parking lot.

The following contractor requirements and information are to include but not limited to the following services and specifications required to provide a fully functioning turnkey lighting system. Lighting Conduit (Designated in Red on the Attachment A. Project Overview Map) The total lateral length of the electrical lighting circuit is 2,440ft. Excavation and installation of 1 Schedule 40, Electrical grade PVC conduit system along a 2,255ft. section of the total circuit length (per Attachment B. UR-LT, Ditch Specification). Electrical conduit shall be connected to the precast conduits of the light post foundations to form a continuous run from electrical service to light and from light to light. Questions regarding this bid or to schedule a site visit will be addressed by contacting Barry Muccio ofthe Wolfeboro Municipal Electric Department at (603)569-6975 or via e-mail: meddirector@wolfeboronh.us Note that a 50ft section of the above 2,255ft, will require a 36 depth and schedule 80 conduit under the proposed private driveway extension of Willow Street. Excavation and conduit installation along a 55ft. section has already been completed during a 2022 parking lot project. The remaining 130ft. will need to be affixed to the walking bridge structure within a galvanized steel EMT (Electrical Metal Tubing) with weatherproof fittings and boxes. Longitudinal runs of conduit will be installed in as straight and direct a line as possible. All conduit end joints, and internal finish shall be free of sharp edges and burrs which could damage the cable while pulling. Provide and Install sand backfill material as a bedding and direct cover material for conduit system as per provided specifications. Backfill and compact the existing excavated material above the sand bedding in 12-inch interval lifts to ensure settling is minimized. Install a continuous caution/warning tape approximately 10 above the conduit and 8 below the finished grade of the ditch line. All buried conduit joints shall be cleaned and glued per manufacturer recoendations. All above grade PVC riser' conduits shall be provided for in Schedule 80 as required.