Renovation of an elderly care / assisted living facility in Green Cove Springs, Florida. Completed plans call for the renovation of a elderly care / assisted living facility.

Clay County is seeking licensed and qualified Electrical Contractors to install and replace electrical components at the Clayton and Mildred Revels Senior Center Commercial Kitchen located at 604 Walnut Street in Green Cove Springs, FL 32043 Work includes, but is not limited to obtaining all locates & permits and providing all materials not specified in this SOW, labor, inspections, hardware and equipment necessary to install or replace the electrical components at the following locations in or near the commercial kitchen: New electrical components for commercial water heater (3 phase 208 volt) (1) new sq-d 80-amp 3 pole breaker. Conduit from panel to the location of heater approximately 60 feet. (1) 3 phase NEMA 1 100 amp non-fused disconnect. Flex from disconnect to the water heater. All connectors, coupling, straps, and hardware need to secure conduits. Pull the wire and terminate. New electrical components for Retherm warmer (40-amp 208 volt) (1) new sq-d 40-amp 2 pole breaker. Conduit from panel to the location of warmer, approximately 45 feet. (1) 3-phase 60 amp disconnect. All connectors, coupling, straps, and hardware need to secure conduits. Pull wire and terminate. New electrical components for commercial oven, replacing commercial flat-top stove (40-amp 208 volt) (1) 100-amp sq-d 3 pole breaker. Conduit from the panel to the location of the oven, approximately 40 feet. (1) 100-amp 3 phase NEMA 1 non-fused disconnect near the oven. Flex from disconnect to the oven. Blank preexisting 120 volt receptacle. Pull the wire and terminate. New electrical components for computer station in office (1) 20-amp single pole sq-d breaker. (1) 20-amp duplex outlet and cover. Conduit from the panel to the location of the work station, approximately 10 feet. Terminate and test. Install one new data outlet, CAT-6 approximately 200 ft from server (2nd floor) (1) new Panduit jack and faceplate. New electrical components for ingredient cooler station (120 volt 20-amp) (1) 20-amp single pole sq-d breaker. Conduit from the panel to the location of the oven, approximately 40 feet. Pull the wire and terminate. New electrical components for overhead circulation fans x3 (120 volt 20-amp) Conduit from panel to the location of fans approximately 80 feet. Surface mount the outlets to the ceiling. (3) 20-amp duplex outlets and covers. Locations are visually depicted in the attached drawing. Electrical breaker-panel has been verified to have space.