Site work for a road / highway in Gretna, Louisiana. Completed plans call for site work for a road / highway.

This work consists of re-aligning primary and/or secondary mast arms which are leaning, twisted and/or misaligned as a result of a natural disaster or other state of emergency. This shall include, but not be limited to completion of electrical splices for severed signal cables in secondary arms. This shall not include alignment of signal heads or signal head replacement; those items shall be paid for under separate items. For severely leaning mast arms, a guy support system may be required to stabilize the mast arm foundation. Guy wire system shall include, but not be limited to, furnishing and installing guy anchors, guy cables, and three-bolt clamps. This work consists of re-aligning primary and/or secondary mast arms which are leaning, twisted and/or misaligned as a result of a natural disaster or other state of emergency. This shall include, but not be limited to completion of electrical splices for severed signal cables in secondary arms. This shall not include alignment of signal heads or signal head replacement; those items shall be paid for under separate items. For severely leaning mast arms, a guy support system may be required to stabilize the mast arm foundation. Guy wire system shall include, but not be limited to, furnishing and installing guy anchors, guy cables, and three-bolt clamps. The Contractor shall re-align existing traffic signal heads which are misaligned as a result of a natural disaster or state of emergency. This shall include, but not be limited to mast arm signal heads, pedestal signal heads, and/or span wire signal heads. The Contractor shall install mast arm and/or strain pole foundations complete with piles, repair and/or furnish and replace underground conduit, and furnish and install all applicable electrical cable. The foundations shall be installed in relative close proximity to the damaged foundation and therefore, minimal conduit should be required. The Contractor shall install a TYPE P Controller cabinet and related equipment to replace an existing controller cabinet and related equipment which has been damaged as a result of a natural disaster or other state of emergency. Related equipment shall include, but not be limited to load switches, transfer relays, communication panel, and detector harnesses wired for 8 phase, 4 overlap operation. The Contractor shall install an electrical service and related equipment for a traffic signal system. Related equipment shall include, but not be limited to, rigid aluminum conduit, meter pan, service box and breakers, and service wire. The Contractor shall install a traffic signal mast arm, pedestal, or strain pole. This shall include supplying the mast arm or pedestal shaft. However, if the Jefferson Parish Engineering Traffic Division can supply a comparable mast arm/pedestal shaft, the contractor shall order a replacement and deliver the replacement to Jefferson Parish upon its arrival. Jefferson Parish shall supply all strain poles