Site work and paving for a sidewalk / parking lot in Bay Village, Ohio. Completed plans call for site work for a 10,350-square-foot sidewalk / parking lot; and for paving for a sidewalk / parking lot.

The Bidding Documents for this project, which include Plans, Specifications and Bid Forms may be obtained by calling (440) 871-1221. There is no cost for the Bidding Documents and they will be issued electronically once requested. Bids must be submitted on the original Bid Forms provided by the City. Additional bidding requirements are identified in the Bidding Documents. 1. Furnish ALL materials, labor and equipment necessary to properly mill and overlay the existing asphalt parking lot per current Ohio Department of Transportation Construction and Material Specifications, and as indicated below. Include ALL incidental costs in lump sum proposal such as mobilization, bonds, insurance, etc. 2. Pavement Planing - Item 254. Mill the existing asphalt pavement at a maximum depth of 2", as needed, to achieve the proper linear grade. All spoils to be hauled off site. The City will not accept material. 3. Partial Depth Repair - Item 251. This item shall consist of the repair of additional deteriorated asphalt after the initial material is milled. The work shall consist of milling & grinding the additional asphalt to a depth of approximately 2" followed by application of tack coat at 0.10 gallons per square yard and placement of two inches (2") per ODOT 441, Asphalt Concrete Intermediate Course, Type 2, (448), PG 64-22. Material to be rolled and compacted prior to placement of other courses of asphalt. This is a Contingency Item and the quantities and location determined will be field marked by the City after pavement planing. Payment for this work will be deducted from the Contingency as measured once completed. It is estimated that there will be approximately (200 Square Yards) of Partial Depth Repair in multiple locations. Any unused Contingency will be credited back to the City by Change Order once the Projectis completed. 4. Tack - Item 407. Apply "trackless" tack coat at a rate of 0.10 gallons per square yard over the swept and cleaned milled surface. 5. Asphalt Concrete - Item 441. Install asphalt in two (2) courses for an overall minimum thickness of two inches (2"). The first "scratch or leveling" course shall be (1/2") PG 64-22, Type 1 (448). The surface course shall be (1-1/2") PG 64-22, Type 1 (448). 6. Hot Applied Joint Sealer - Item 705. Edge seal at ALL joints, castings, curb joints and vertical abutting surfaces, as required. Apply liquid de-tacking agent over edge seal after application, as needed. 7. Traffic control will be maintained by Contractor at all times during Work as needed. This includes coordinating with the City during work as to not disrupt function of adjacent businesses and Post Office operation, across the street from site. 8. Any damage to site and properties due to advancing work phasing prior to material being ready for traffic will be cleaned and/or repaired by the Contractor to the satisfaction of the City at no additional cost. 9. Painting of parking lot spaces and striping will be performed by the City and is not included in this scope of work. 10. A $20,000.00 Contingency will be included in this Bid, pre-labeled in Bid Forms and to be added to the "Total Bid Amount" of the Bid. Bay Village Municipal Parking Lot (Located at Dover Center Road & East Oviatt Road) Asphalt Area: 1,150 Square Yards (Aerial Map attached)