Renovation of a fire / police facility in Chester, South Carolina. Completed plans call for the renovation of a fire / police facility.

Materials and Labor to remove existing diesel generator; to install and connect new 400-amp natural gas generator set to 300-amps. Generator is to be used as non-required total building standby power system. The City reserves the right to accept or reject any or all bids in whole or in part and to award a contract that is in the best interest of the City. A bid bond is required for all contracts that exceed $100,000. For questions or additional information, contact Chief James Jackson, 803-385-2123, jjackson@chesterfiredept.com. The owner reserves the right to waive any irregularities, or to reject any or all bids. Scope of the work: Materials and Labor for existing building roof repairs, damaged roof insulation replacement and wall insulation repair with protection for engine room exposed wall insulation. Work to include: Coordinate disconnect and removal of existing generator (existing conductors to transfer switch to be re-used). Coordinate the purchase, delivery, unloading and installation of a new Kohler Model KG100 generator with 300-amp set breaker on existing concrete pad connecting with existing underground conduit and conductors. Disconnect and remove existing transfer switch. (Existing back-up panels will need to be temporarily supplied with power during installation of the new transfer switch.) Provide and install ASCO Series 300 Automatic open transition 400-amp transfer switch (wall mounted, 3 pole, 3 phase, 4 wire, 208 volt with min 2 year warranty) at existing location in electrical room (basement area of building). Provide proper sized natural gas pipeline and regulator to connect generator from existing Chester County Natural Gas service meter. (Note existing gas meter is located at front of building and will need to be run through building space to rear of building and to new generator.) Relocate existing 100-amp Admin electrical panel feeders to generator emergency panel. Remove disconnect to Admin electrical panel located in ceiling area of truck bay and reconnect electrical feeder conductors to Admin electrical panel. Provide acceptance test according to manufacturer's instructions and minimum standard (+/- 10 second) power restoration, 4-hour load bank test and 2-hour building load test. Provide start-up assistance after installation is completed. Provide manufacture warranty