Renovation of an educational facility in Chicago, Illinois. Completed plans call for the renovation of a educational facility.

1. Procurement of all necessary permits and inspections as required by the local jurisdictions, and compliance with all applicable code requirements. 2. Verification of all dimensions and conditions at the jobsite. The contractor shall make any necessary adjustments as required to provide proper clearances and masking. Any deviation from the drawings or these specifications shall be made only after approval of the owner has been made in writing. 3. Receive at the jobsite all lighting, control, distribution, and accessory equipment as scheduled in the attached bill of materials and as provided by the lighting systems integrator. Provide complete installation of the lighting and control system according to the project documents, including all conduit, wiring and other unscheduled equipment and materials as required for complete installation of the lighting and control system. 4. Install the new feedthrough relay panel at the existing panel board location. Provide and install new 20 ampere, single pole circuit breakers as required and extend 6 new 2 wire stage lighting circuits to the new relay panel using not less than #12THHN conductors and dedicated neutrals. 5. Install four new front-of-house single circuit plug-in boxes at the existing gymnasium pipe battens as directed by the lighting systems integrator. Extend one new stage lighting circuit from each box to the new relay panel using not less than #12THHN conductors and dedicated neutrals. Provide and install new P-1000T Unistrut channel at the existing gymnasium pipe battens for future fixture installation as directed by the lighting systems integrator. 6. Disconnect, remove, and dispose of the existing continuous border light strip at the front of the stage. Adjust the elevation of the existing pipe batten as directed by the lighting systems integrator and install new 2 circuit plug-in box as directed by the lighting systems integrator. Extend two stage lighting circuits to the new relay panel using not less than #12THHN conductors and dedicated neutrals. 7. Install the new control distribution panel as directed by the owner and the lighting systems integrator. Provide local 120vac power supply to the new control distribution panel. Extend 6 Belden #9729 control cables from the control distribution panel to the new relay panel and five new plug-in boxes in a home run configuration. 8. Provide a new 3 gang back box and install the new touchscreen control station at the gymnasium entrance as directed by the owner and the lighting systems integrator. Extend 2 - #16AWG low voltage power supply wires to the new control distribution panel. 9. Provide new single gang back boxes at the gymnasium and the stage as directed by the owner and install 2 new control receptacle stations. Extend one Belden #9729 between the new touchscreen control station, the control receptacle stations, and the new control distribution enclosure in a serial or "daisy chain" configuration 10. Provide new two gang back box and install new preset push button control station at the stage as directed by the owner. Extend one Belden #1583A control cable to the control distribution enclosure. 11. Install, focus and adjust all new stage lighting and accessory equipment as directed by the owner and the lighting systems integrator. 12. Provide demonstration of the completed installation, and any necessary adjustments of systems and components required for complete and proper operation. 13. Submit record drawings as required by the owner. Questions Due Date: Jul 17th 2023, 1:00 PM CDT