Renovation of an educational facility in Rock Hill, South Carolina. Completed plans call for the renovation of a educational facility.

Replacement of existing fire alarm system in Bancroft Hall (60,668 SF) with fire alarm voice evacuation system. Project Location: Bancroft Hall, 1882 Alumni Dr Rock Hill SC 29733 Construction Cost Range: $150,000 to $250,000 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. he following items shall be incorporated into the bid documents. Bidder shall include all effects which these items may have on Bidder's proposal. 1. Ceiling in building has paracube louvers at approximately 8' AFF. Speaker strobes shown on the ceiling are to be moved to the wall, mounted tight to ceiling with no exposed conduit. This will place devices at approximately 7'5" to center of strobe. Where devices are required in rooms adjacent to corridor, conduit will be installed above ceiling only and punch through to device in room. No exposed conduit will be allowed. Some devices in rooms may be a few inches higher than the corridor devices. No device can be mounted above 96". 2. Conduit shall be run at the top of the walls above ceiling and shall be painted white. Junction boxes shall be identified with RED painted covers. 3. Location of penetrations between floors shall be confined to the area in the corridor above the FACP location and below. All penetrations of flooring will have to be surveyed for asbestos prior to penetration. See attached Comprehensive Interior Asbestos and Lead Inspection Report from Crossroads Environmental, LLC. 4. 120-volt power for FACP and required NAC panels will come from area 120-volt panels. FACP power will use same circuit as the existing FACP that is being removed. 5. All conduit penetrations to toilets indicating waterproof devices shall have all voids around conduit sealed with Duct Seal or equal to prevent the passage of moisture. All other penetrations shall be sealed with Fire Caulk to equal a minimum of 2 HR assembly. 6. Add relay module for new 24-volt sprinkler bell that will replace the existing water gong. Relay Module to be programmed to power bell only as long as the water is flowing and reset when water flow stops. 7. Contractor to provide an on-site mockup of the planned conduit/wiremold installation for typical devices prior to the beginning of installation for review and approval by owner. All exposed wiring shall be in Wiremold with manufactured fittings at penetrations to cover gaps. Install grommets where cable exit the wiremold. All exposed boxes shall be finished with paint finish. 8. All exposed conduit/wiremold shall be painted to match the wall it is installed on. 9. All floor penetrations and all corridor wall penetrations shall have 1 hour fire sealing applied All questions & correspondence concerning this Invitation shall be addressed to the A/E. A/E NAME: Burdette Engineering, Inc. A/E CONTACT: Don Burdette, PE EMAIL: dburdette@burdetteengr.com TELEPHONE: (864) 297-8717