Site work for a road / highway in Payson, Arizona. Completed plans call for site work for a road / highway.

As of September 20, 2023, project has not been awarded yet. A timeline for award has not yet been established. Each Bid submitted, either by hand, United States Postal Service, or other carrier, shall be sealed and plainly marked BID NO. 071023, GISELA ROAD ROADWAY IMPROVEMENT PROJECT. All Bids shall be mailed or delivered to the Gila County Procurement Department, Attention: Betty Hurst, Contracts Manager, 1400 East Ash St., Globe, AZ 85501. Gila County Engineering Services and Board of Supervisors of Gila County will not be responsible for those bids submitted that are not marked appropriately or sent to the wrong address. The prevailing clock shall be the atomic clock in the reception area of the Copper Building. Contractors shall be responsible for any licenses or permits required by the regulatory agency of the State of Arizona that apply to the performance of this contract. After the Contractor who is determined to be most advantageous to the county has been selected through the source selection process, negotiations may be conducted for the purpose of developing a recommended Contract for Award. The Gila County Board of Supervisors reserves the right to reject all bids, or to waive any informality in any bid. All procurement activities conducted by Gila County are in conformance with the rules and regulations of the Gila County Clerk of the Board's office. A copy of the Code is available for review in the Clerk of the Board's office, Globe, AZ. Requests for clarification shall be made to Betty Hurst, Contracts Administrator in writing bhurst@gilacountyaz.gov. Questions can be submitted up until 3:00 P.M., AZ time, on Wednesday, August 23, 2023. Addendums will be issued to all plan holders as they come in, and prior to 3:00 P.M., AZ time, on Monday August 28, 2023. The proposed work is on Gisela Road for approximately 1.70 miles from the roadway high point to the Tonto Creek Shores Intersection. The improvements consist of milling the existing chip seal, compacting the milled material in place, and placing an emulsified double chip seal with a fog coat on top of the compacted material. Additional work includes widening three curves to improve visibility and drivability. New striping will also be placed on the chip seal.