Site work for a road / highway in Onamia, Minnesota. Completed plans call for site work for a road / highway.

commercial exterior renovation project at the Roads Garage located at 43188 Timber Trails Rd, Onamia, MN 56359 Work Scope: Demo and replace top row of block on the rear (roadside) and office area side (northeast) exterior walls of the facility. Match existing. Supply and install 22 gauge metal drip edge on all exterior block walls. Tuck under existing edge and secure with short self-tapping screw. Flashing shall extend over and down the top row of block with drip edge extending just below mortar joint. Match existing flashing in color. Panel Fasteners: Self-tapping screws designed to withstand design loads. Provide exposed fasteners with heads matching color of metal panels by means of plastic caps or factory-applied coating. Provide EPDM or PVC sealing washers for exposed fasteners. Apply continuous bead of butyl caulk at joint per drawing detail. Pressure wash all exterior block. Remove any remaining moss, etc. Clean block using MASONRY CLEANER. Proprietary Acidic Cleaner: Manufacturer's standard-strength cleaner designed for removing mortar/grout stains, efflorescence, and other stains without discoloring or damaging masonry surfaces. Use product expressly approved for intended use by cleaner manufacturer and manufacturer of masonry units being cleaned. 1. Manufacturers: Subject to compliance with requirements, provide products by one of the following: a. Diedrich Technologies, Inc. b. EaCo Chem, Inc. c. ProSoCo, Inc. Supply and install all materials and labor to complete tuckpointing to repair all damaged mortar. Match existing mortar color. Seal all block walls with clear Water Seal. Product to be approved by owner. Demo and replace damaged panels of steel siding on front side of the cold storage building. Note: the entire length of each damaged panel does not need to be replaced but at minimum the lower 4' of each damaged panel shall be replaced. Tuck the new siding panels behind the existing upper siding panel sections. New steel to match existing in gauge and color. The Band reserves the right to reject any bid that it is unable to collect at the Onamia post office by the bid deadline date and time, provided that the Band has made diligent and reasonable efforts to collect the bid. The Band reserves this right even in the event that the bid has been postmarked before the deadline. Bonding Requirements: In construction contracts that are federally funded or deemed commercial, bonding is required. These types of contracts shall demand a performance bond of not less than twenty percent (20%) of the total contract price, but not to exceed $500,000.00. A performance bond requirement is to ensure that, if a contractor defaults, the Band may request that the surety pay the expenses incurred to complete the construction contract. In addition, all construction contracts identified as federally funded or commercial, shall be covered by a payment bond equal to one payment installment to cover subcontractors/ suppliers as determined by the Contracting Officer or his agents. The payment bond must contain language stating that if the contractor fails to make a payment to its subcontractors/suppliers, the surety will make the necessary payment. All Contractors must comply with all Mille Lacs Band of Ojibwe American Indian Employment requirements (see 18 MLBSA 5). Contact Lori Trail at (320) 532-4778.