Site work and paving for a sidewalk / parking lot in Culver City, California. Working plans call for site work for a sidewalk / parking lot; and for paving for a sidewalk / parking lot.

Parking lot seal and stripe services at the Culver City DMV Field Office. The Contractor shall clean existing asphalt surfaces and complete all minor asphalt repairs and oil removal as indicated on the plans, specifications or indicated at the job walk. Fill all cracks over 1/4" wide with pre-approved rubberized crack filler. Drawing A-1 is part of contract. The Contractor will apply two (2) or more coats of asphalt seal covering on all asphalt surfaces. First coat shall dry before second coat is applied. Work includes replacement and reinstallation of broken concrete wheel stops: Realign and pre-drill loose wheel stops and replace broken or damaged wheel stops. The Contractor shall repaint existing painted curbs, arrows and symbols with same original colors and re-stripe per specification all existing spaces and lines. Entrance curbing at motorcycle test area to be painted red The services shall be performed at: 11400 W. Washington Blvd., Culver City, CA 90066 Question Deadline 09/26/2023 at 10:00 AM PT The contact person for this IFB is: Allison Stanek Department of Motor Vehicles Phone: (916) 818-2848 Email: Allison.stanek@dmv.ca.gov The bidder shall possess a valid C-12 or C-32 contractor license issued by the California Department of Consumer Affairs, Contractors State License Board (CSLB) Contractor shall provide the DMV with a payment bond equal to one-hundred-percent (100%) of the total amount payable under this Agreement when the Contractor's total bid amount exceeds $25,000.00