Renovation of a fitness / recreation center in Milpitas, California. Completed plans call for the renovation of a fitness / recreation center.

The Contractor shall perform all Work within the time stipulated in the Contract, and shall provide all labor, materials, equipment, tools, utility services, and transportation to complete all of the Work required in strict compliance with the Contract Documents as specified in Article 5, below, for the following Project: SPORTS CENTER ROOF REHABILITATION PROJECT The Contractor and its surety shall be liable to the City for any damages arising as a result of the Contractor's failure to comply with this obligation. The estimated cost for the project is $496,000. Sports Center Roof Rehabilitation Project. Question Deadline 10/11/2023 at 2:00 PM PT Questions regarding this Notice Inviting Bids may be directed to Steve Pietrobono/Buyer, AT 408- 472-8085 or email aspietrobono@milpitas.gov. No other members of the City's staff or CitCouncil should be contacted about this procurement during the bidding process. Any and all inquiries and comments regarding this Bid must be communicated in writing, unless otherwise instructed by the City. The City may, in its sole discretion, disqualify any Bidder who engages in any prohibited communications. The City is seeking a certified, licensed contractor to provide the equipment, tools, and personnel for the rehabilitation of the roof and all necessary HVAC duct work to meet Title 24 requirements at the Milpitas Sports Center (1325 E. Calaveras Blvd., Milpitas, CA 95035) 1. Pressure wash roof at areas to receive fluid applied restoration. 2. Repair any blisters, fish mouths, splits or tears in (e) roofing. 3. Replace any areas of wet insulation. 4. Replace all sealant on penetrations and surface mounted counterflashings. 5. Build up any low areas in roof by installing an additional layer of Powerply Standard FR HW. 6. Install AlphaGuard MTS Base Coat at 4 gallons per square. 7. Install 1 ply Permafab in wet base coat. 8. Install AlphaGuard MTS Top Coat at 2 gallons per square over cured base coat. 9. Install 500 lf of slip resistant walk-way.