Site work for a municipal facility in Baton Rouge, Louisiana. Completed plans call for site work for a municipal facility.

Ashland Field in Natchitoches Parish. Evidence of authority to submit the bid will be required in accordance with R.S. 38:2212 (A)(1)(c) and/or R.S. 39:1594 (C)(2)(d). 1. Remove debris from well area to allow safe access to well site. Make necessary repairs on wellhead. Install blow out preventers and test to 29B standards. Verify that the hydraulic closure system is operational at all times. Check and record well pressure on tubing and casing. Kill well if necessary. Establish injection rates and pressure in the tubing (or production casing if tubing not present). Monitor casing pressure during injection or if necessary, pressure up on casing to determine tubing and casing integrity. Pressure test all casing strings and annuli to 300 psi. If no production packer present forego production casing pressure test. Note: Report all rates and pressures to District Office. 2. Pull and lay down rods, if necessary. Pull production tubing and packer from wellbore and lay down. Verify wellbore is cleaned out to CIBP OD size. 3. Set CIBP plug @ 2,800'. Tag CIBP. Place a minimum of 10' of cement above CIBP. 4. Set CIBP plug @ 1,450'. Tag CIBP and test to 300 psi. Place a minimum of 10' of cement above CIBP. 5. Spot 200' cement plug @ 620'-820' for USDW. 6. Perforate at 360' and squeeze a minimum of 100' of cement into annulus. Place 100' balanced plug in wellbore from 260'-360'. a. If unable to inject into perforations, place 100' cement plug inside of wellbore. Wait on cement 4 hours. Tag and pressure test cement plug to 300 psi. 7. Set 100' surface plug. Circulate balanced cement plug in the production casing. Using a small diameter pipe circulate a 100' cement plug in all casing annuli. Verify all casing annuli have cement at surface, if not top off. 8. Cut and remove wellhead 5' below ground level. Weld plate with serial number and date welded on to well. 9. Restore wellsite and restore any damage caused by P&A operations on the site and access route to well location. Removed all equipment associated with the production of this well.