Site work and paving for a sidewalk / parking lot in Henning, Tennessee. Completed plans call for site work for a sidewalk / parking lot; and for paving for a sidewalk / parking lot.

Fort Pillow State Park Campground Parking Pads. Scope. The Contractor shall provide all goods or services and deliverables as required, described, and detailed in the Scope or Specifications set forth in the Invitation to Bid and meet all service and delivery timelines as specified by the Invitation to Bid. The absence of detailed specifications or the omission of detailed descriptions shall mean that only the best commercial practices and only first quality goods and workmanship shall be supplied. Question Deadline 12/08/2023. The response must be received by the State on or before the date and hour designated for the response opening. Responses that are submitted untimely shall be rejected. Only the Facilities Management Office can approve any alterations, modifications, or substitutions to the written scope, specifications, or requirements of the project. No additional work shall be authorized unless pre-approved by the Facilities Management Office. All bids over $100,000 shall include provisions for a payment bond in the amount of twenty-five percent (25%) of the contract price. (i) intellectual property or any Contractor indemnity obligations for infringement for third-party intellectual property rights; (ii) any claims covered by any specific provision in the Contract providing for liquidated damages. This solicitation is to bid for a four (4) month contract for the provision of concrete parking pads at Campground Sites 1, 4, 9, and 13 for Tennessee Department of Environment and Conservation at Fort Pillow State Park Prospective respondents must direct communications concerning this ITB to the following person designated as the Solicitation Coordinator: Kyle Villagomez Department of General Services, CPO 312 Rosa L Parks Avenue, 3rd Floor Tennessee Tower Nashville TN 37243-1102 6155321339 Kyle.Villagomez@tn.go 1. Shall install 4 new campground sites 1, 4, 9 and 13 concrete parking pads. 2. All 4 campsites shall be flagged and laid out at time of pre-bid. 3. Campsites 1, 4, 9 and 13 shall all get new siemens 50/30/20amp RV pedestals run in conduit to campsites and new water lines to supply new water hydrants at campsites. 4. The Contractor shall provide and install a 60-inch-tall direct burial 20-30-50 RV power pedestal on each site by means of attaching power conduit in manufacture provided location on each pedestal. The Contractor shall ensure there is 24 inches buried on each pedestal with 33-c gravel tamped and compacted at 4-inch intervals to support pedestal and back fill the excavation site. The Contractor shall attach power legs, grounding, and bonding per manufactures specifications and the 2017 edition NEC. The Contractor shall ensure the receptacles are facing the left (drivers' side) side of the site with a minimum 48-inch clearance from camper pad to power pedestal. 5. The Contractor shall cut each water supply line at a point 48 inches from its existing location. The Contractor shall install 1 quarter turn ball valve at this point. The connection between this ball valve and the new hydrant shall be comprised of blue cold PEX- A-water piping. A brass thread to PEX -A- shall be used to connect to the hydrant. 6. The Contractor shall provide 1 valve box at each location of each valve installed. 7. Water hydrants shall be labeled 3-foot burial and shall have pea gravel/washed stone drainage base for the hydrant drain. The drain base shall be a minimum 1 cubic foot.