Renovation of a residential development in Mobile, Alabama. Completed plans call for the renovation of a residential development.

o Remove existing HVAC unit. o Install a new heating and air conditioning system. (Goodman, Nutone, or equivalent) electric heat pump system. o The new unit shall be sufficient to properly heat and cool the entire house. o It shall be the contractor's responsibility to ensure that the new unit is properly sized. o New unit shall be high efficiency. Minimum of 14 seer. o Modify existing duct work to ensure proper operation of new unit. o Repair any damaged duct work. o Add any duct work necessary to ensure proper heating and cooling in all areas of house. o Upon completion of this scope of work all ductwork shall be insulated metal duct. Short runs of flexible duct may be used for connecting to supply registers and boots. o Ensure that all ductwork is well supported and properly strapped in place. o Ensure that return grille is working properly and of adequate size. o Replace all supply registers and return grill. o Clean any existing ductwork that will be re-used. o Insure attic is insulated to R-30 after all necessary repairs are done. o Homeowner shall be supplied with 12 additional filters and informed on the changing of filters and the frequency that they should be changed. o Install a new properly matched thermostat from a recognizable manufacturer. o A properly sized manufactured condensing unit pad must be used. o Existing pad may be re-used if it is not damaged and is of adequate size. o Pad must be level. o Contractor must educate Homeowner on proper operation and maintenance of new unit. o Manufacturer's consumer literature on the unit must be left with the Homeowner along with warranty information on the unit. o The contractor shall include all items necessary to ensure the proper operation of this unit. This includes all connections to the gas service, the electrical disconnect, and electrical service to the unit and venting to meet code.