Renovation of an educational facility in Asheville, North Carolina. Completed plans call for the renovation of a educational facility.

Remove existing water heater and tank and install two (2) HTP Phoenix Model PH199-119 modulating, high-efficiency, condensing gas-fired water Question Deadline 01/15/2024 at 5:00 PM ET Please direct all project related RFP questions to Chad Allen, Project Manager. Questions should be submitted via email to chad.allen@bcsemail.org Contractors are hereby notified that they must have proper license under the State laws governing their respective trades and that North Carolina General Statute 87 will be observed in receiving and awarding contracts. General Contractors must have general license classification required by this project. No bid may be withdrawn after the opening of bids for a period of thirty (30) days. Buncombe County Schools reserves the right to reject any or all bids and waive informalities. Bids shall be made on the Bid/Acceptance form provided herein with all blank spaces for bids properly filled and all signatures properly executed. Work shall consist of furnishing all labor, materials, equipment, permits, and servicing, incidental and implied, for the completion of a working system as designed per the attached specifications. Remove the existing water heater/boiler and tank; all unused piping, electrical components, and wiring not needed for the operation of the new water heaters. Onsite dumpsters shall not be used. Modify or construct 6" concrete pads at the location of the new water heaters if none are present. Install (2) HTP Phoenix Model PH199-119 Modulating, High Efficiency, Condensing gas-fired water heater. (per manufacturer recommendations) Extend the gas line to new water heaters. Shut off valve and line pressure regulators to be included. (gas line shall be painted yellow and labeled) All pumps, piping, valves, venting, and insulation shall be included. All new pipes are to be insulated with fiberglass insulation. Replace the expansion tank (If needed). The tank shall be installed off the ground. An Apollo ball valve shall be installed between the water heater and the expansion tank. All wiring, accessories, and disconnects shall be included. All exposed low-voltage wiring shall be in rigid conduit. Add HTP Modbus/ Bacnet gateway/adapter to allow BAS to communicate with the water heaters. (the owner will perform control wiring and integration) Factory Start-up, Adjustment, and Combustion test reports shall be part of this contract. One paper copy and two digital copies on a USB (thumb) drive of the completed factory start-up sheet, installation, operation and maintenance manuals shall be delivered to the owner before final payment will be made. All old equipment, piping, wiring, and venting no longer needed shall be removed Specifications: HTP Phoenix Model PH199-119 Modulating, High Efficiency, Condensing gas-fired water heater 40 to 199 MBH Input 119-gallon storage capacity 237 GPH @ 100 deg. F. rise (335 Gallons @ 100 deg. F. rise First Hour Rating) Complete with: Up to 96.1% Efficiency FULL MODULATION, 5:1 turndown Sealed Combustion Factory assembled & fire tested Low NOx rating 316L stainless steel tank Polyurethane foam insulation High-impact plastic jacket Removable front cover 90/10 Cupronickel & SS heat exchanger Pre-mix stainless steel burners T&P Relief valve Self-diagnostic electronic control Digital display 70 to 160 deg. F. Operating Range Upper & lower temperature sensors High limit safety Low water cutoff Direct spark ignition Condensation trap assembly Intake/exhaust via PVC pipe UN/ULC/ANSI approved BACnet card shall be included Buncombe County Schools-RFP 18.23 Page 17 of 28 Made in the USA